Baumer PMG10P Manuel d'utilisation - Page 18

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Baumer PMG10P. Baumer PMG10P 44 pages. Absolute encoder
Également pour Baumer PMG10P : Instructions de montage et d'utilisation (32 pages), Instructions de montage et d'utilisation (36 pages), Instructions de montage et d'utilisation (32 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (36 pages)

Installation

g) Fasten the coupling onto the shaft of the drive at a torque of 1.3 ±10 % Nm.

Observe the remarks in the data sheet and the coupling assembly instructions.

Maximum permitted tolerances for mounting errors when using the

5.3

Baumer Hübner K 35 spring washer

NOTICE

Damage to the encoder ball bearings.

Hard impacts of the drive shaft imposed on coupling parts may damage the ball bearings.

a) Prevent any hard impacts of the drive shaft on coupling parts.

Instruction:

a) Mount the drive with small angular error and parallel offset.

b) Note the following allowable mounting errors:

The figure shows the device with EURO flange B10, the same maximum permissible mounting

errors must be observed for the device with housing foot B3.

Permitted parallel misalignment

* With insulated plastic hub

Ill. 7: Permissible mounting errors (dimensions in mm)

Permitted angle error

Operating Manual

Baumer Hübner

Permissible axial movement

±0.7 (±0.3*)

PMG10 & PMG10P DeviceNet | V1