Douglas Lighting Controls Dialog WIR-3110 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Douglas Lighting Controls Dialog WIR-3110. Douglas Lighting Controls Dialog WIR-3110 11 pages. Ir setting unit

Imprimer la page

Douglas Lighting Controls Dialog WIR-3110 Manuel de l'utilisateur

Setting a Switch

Step 1 -

Switch Configuration

Using the UP/DOWN buttons, move the cursor until it highlights the '#-Button Switch' field.

Select the switch configuration that matches the switch that you are programming by

rotating the scroll wheel clockwise or counterclockwise.

Step 2 -

Input Type

Using the UP/DOWN buttons, move the cursor until it highlights the 'Type' field. Select the

switch input type to apply to the switch that you are programming by rotating the scroll

wheel clockwise or counterclockwise.

Step 3 -

Assigning an Address

Using the UP/DOWN buttons, move the cursor until it highlights the 'Addr' field. Select

the address you wish to assign the switch by rotating the scroll wheel clockwise or

counterclockwise.

Step 4 -

Assigning an Output Channel

Using the UP/DOWN buttons, move the cursor until it highlights the 'Addr' field. Select

the address you wish to assign the switch by rotating the scroll wheel clockwise or

counterclockwise.

Step 5 -

Assigning a Function

Using the UP/DOWN buttons, move the cursor until it highlights the 'Fn' field. Select

the function you wish to assign the switch by rotating the scroll wheel clockwise or

counterclockwise.

Step 6 -

Delay ON

Using the UP/DOWN buttons, move the cursor until it highlights the 'On' field. Select the

amount of time you wish to delay an ON command after it is initiated. The time can be

adjusted from 0 seconds to 40 minutes by rotating the scroll wheel clockwise.

Step 7 -

Delay OFF

Using the UP/DOWN buttons, move the cursor until it highlights the 'Off' field. Select

the amount of time you wish to delay an OFF command after it is initiated. The time

can be adjusted from 0 seconds to 40 minutes by rotating the scroll wheel clockwise or

counterclockwise.

Step 8 -

Writing Programming to a Switch

Using the UP/DOWN buttons, move the cursor until it highlights the bottom right field.

Rotate the center scroll wheel until 'Write' is highlighted. Point the Infrared transmitter

approximately 0.5"away from the IR lens of the switch being programmed and press the

center button of the IR Setting Unit. You will hear a single solid beep sound indicating that

the switch was successfully programmed.

PAGE 5

Setting a Switch

*Instructions apply for a Key Switch as well

universaldouglas.com