Doulton HIS Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Doulton HIS. Doulton HIS 2 pages. Push-fit filter
Imprimer la pageFor a new filter element, the maximum flow rate will be achieved once the
ceramic filter element has become fully saturated; to allow the filter element to be
conditioned to the source water, allow the unit to stand unused for a further 24
hours and then run the first 15 litres of water to waste.
The filter is now ready for use.
Due to filtration of particulate contaminants from the water during use, the flow
of the water from the filter may deteriorate over a period of time. To restore the
water flow to its normal level, simply remove, clean and replace the filter element
as follows:
3.
Servicing the Filters
It is important to wear rubber gloves or wash your hands thoroughly before and
after servicing the filter and filter element.
Removal, cleaning and reinstallation/replacement of the filter element is carried out
as follows:
With the upstream isolation valve turned off, vent any pressure by opening the user
tap.
Place a bowl of under the filter body and unscrew the filter body, which will be full
of water. Lower the body into the bowl. The filter element can now be unscrewed
from the filter head and cleaned in accordance with the manufacturer's instruction
or replaced as described in Section 1.3.
When the filter element have been re-installed, wipe the filter housing clean with a
damp cloth and refill the filter system as described in Section 2.
Cleaning/Sterilising the System
To clean the housing wipe externally with a warm damp cloth. The following
substances should be avoided:
•
Strong oxidising agents such as bleach or Milton solution
•
All strong acidic materials including some descalents
•
Strong alkaline material
A filter element that has reached the end of its life would be indicated by a
reduction in the taste quality of the filtered water. The filter element should be
replaced in accordance with the rated service capacity, which would typically give
a period of six months usage.
Manufactured by:
Doulton Water Filters, Newcastle, Staffordshire, ST5 9BT, United Kingdom.
Telephone:
+44 (0) 1782 664420
Fax:
+44 (0) 1782 664490
Email:
Website:
www.doulton.com
Doulton
is a trademark registered to Fairey Industrial Ceramics Limited.
®
W2393021 Issue 3
October 2016 Fairey Industrial Ceramics Limited trading as Doulton Water Filters.
www.doulton.com
A GENUINE
WATER FILTER
A GENUINE WATER FILTER