Amphenol 957-7610 Procédure d'assemblage

Parcourez en ligne ou téléchargez le pdf Procédure d'assemblage pour {nom_de_la_catégorie} Amphenol 957-7610. Amphenol 957-7610 3 pages. Rj sealed connectors

Imprimer la page

Assembly Procedure for RJ Sealed Connectors

Procedure to be used for terminating and assembling of Amphenol Connector Kit Part Number 957-7610

Step 1: Feed CAT cable through boot and connector housing as shown below.

Note: Care should be taken not to damage the rubber sealing gasket inside the rear of the

Step 2: Terminate RJ-45 connector onto CAT cable

A) Strip jacketing and shield as shown

B) Fold shield back onto jacketing.

Wrap drain wire one and a half times

around the shield.

Trim excess length from drain wire

Amphenol Fiber Optic Products – 2100 Western Court, Suite 300 – Lisle, IL 60532 – P (800) 944-6446 – F (630) 810-5880 www.amphenol-fiberoptics.com

Page 1 of 2

connector housing.

C) Untwist pairs and arrange to desired order.

Note: It is recommended to follow TIA-

568 specifications for wiring orientation

Trim conductors at an angle and insert into

the loading bar

D) Trim excess wire from holder

Insert prepared cable into RJ-45 Plug

949-1690 Rev. B