Amphenol AMPHE-EX L-2124 Manuel d'instructions de montage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Amphenol AMPHE-EX L-2124. Amphenol AMPHE-EX L-2124 17 pages.

Imprimer la page

•

The interface between the panel mount receptacles and associated increased safety enclosure to which they may be

fitted cannot be defined. Therefore it is the user's responsibility to ensure that the appropriate ingress protection level

of the associated enclosure is maintained at this point.

•

When marked with the code Ex op pr IIC T6 Gb or Ex op pr IIC T6 Gb, the connectors are only to be installed within

an Ex d IIC GB rated enclosure, suitable for the assigned ambient temperatures.

•

When marked with the code Ex op pr IIC T6 Gb or Ex op pr IIC T6 Gb, any fibre optic cable must be protected in

accordance with the relevant code of practice.

Conditions Of Manufacture

•

When equipment is used as Ex op is IIC, the fibre optic source supplying this equipment shall be suitable certified as

compliant with EN 60079-28:2007 and provide an inherently safe optical source (op is), EPL Gb, subsequently the

following parameters apply:

Application, Temperature Class, Max. Surface Temperature & Ta Max.

Fibre optic source limited to a maximum signal power

of 15 mW and a maximum irradiance of 5 mW/mm² (surface

area not exceeding 400mm²)

Conditions of Use

Warnings:

Do not open when an explosive gas or dust atmosphere is present. Do not separate while energized.

Supply conductors shall be suitable for a cont. oper. temp. of at least 90°C. (in cases where (-40°C≤Ta≤+40°C)) Supply

conductors shall be suitable for a cont. oper. temp. of at least 105°C. (in cases where (-40°C≤Ta≤+55°C))

Hermetic Supply conductors shall be suitable for a cont. oper. temp. of at least 125°C. (in cases where (-

40°C≤Ta≤+85°C))

Fibre optic source limited to maximum signal power of 35 mW

and a maximum irradiance of 5mW/mm²

exceeding 400 mm²)

Page 6 of 17

(surface area not