Baumer NE215 Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Baumer NE215. Baumer NE215 40 pages. Electronic preselection counter

Imprimer la page

Programming mode

Programming mode Operating parameters are set in the programming mode, which is

Programming segment 1

Programming segment 2

Programming segment 3

Programming segment 4

To access programming The same key assignments apply to the individual programming seg-

Function in operating and

programming modes

Function in operating and

programming modes

Function in operating and

programming modes

Function in the operating mode Deletes the display. Reset of possible programmed operating

Function in the programming mode Deletes the display. Reset of possible programmed operating

Function in the operating mode Transfer from any display to a parameter corresponding the selection

Function in the programming mode In conjunction with the

Programming mode

This section describes the procedure for programming the counter.

subdivided into four programming segments.

In the first programming segment, all the operating parameters

can be accessed and changed. The operating parameters which are

disabled in the operating mode are also displayed here. The first

programming segment consists of 8 lines.

In the second programming segment, the individual operating

parameters for access to the operating mode can be disabled and

enabled. In the first programming segment, access is possible to

these disabled operating parameters.

In the third programming segment, all the machine-related

functions and values can be programmed.

In the fourth programming segment, the interface parameters can

be programmed.

Keying

ments. Since key functions may vary in the operating and program-

ming modes, however, all the functions are described in full below.

Key

Transfer to the next operating parameters in the operating and

programming modes. For a fast run-through, hold the key down.

Key

Transfer from programming to operating mode and vice versa.

Keys

...

Change of values via the numerical keypad.

Key

continuous contacts.

continuous contacts. Selection of output signals on continuous

signal (latch).

Key

in line 35.

NE215

key, transfer to programming mode.