Amphenol Temposonics MH Series Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Amphenol Temposonics MH Series. Amphenol Temposonics MH Series 12 pages. Analogue/pwm tester
Également pour Amphenol Temposonics MH Series : Manuel d'utilisation (18 pages)
Imprimer la page
M-Series Tester
User's Manual
2. Installation (continued)
2.6 Carrier Handle Adjustment
To adjust the position of the carrier handle of the tester, please press and hold both buttons on the side of the handle at the same time. Adjust the position of the
handle. After the adjustment release the buttons.
3. Operation
3.1 Start-Up
Perform the following start-up procedure:
1. Turn the tester power switch to the 'ON' position. The test box display will now
cycle through the startup display sequence:
a) LED test for 1 second
b) Software Data test 1 second
c) Currently active Mode for 5 seconds
The default mode setting is configured for voltage at the factory, but after the initial use, the tester will start up in the last mode the tester was set to.
2. If required, change the mode by pushing the 'A' button. (see 3.2 Mode Selections).
3. Repeat step 2 until the appropriate mode is selected and seen on the display.
3.2 Mode Selections
Mode
Voltage
Current
Battery
PWM
TOF
3.2.1 Voltage (Volt)
The voltage range will be displayed in Volts for the M-Series sensor with voltage output. It will depend on the sensor model selected.
MTS Sensors
Note:
1. The tester switch is in the 'ON' position when the red LED is lit.
2. If the LED on the power switch is not lit, the device might be in low power
mode and the power supply needs to be connected to the charger port on
the top of the tester.
Display
Volt
Curr
Batt
Puum
tOF
I
8
I
Unit
Volts
Milliamps (mA)
Display battery voltage
% of Display
Millimeters (mm)