Dover TWG TULSA WINCH 1500W Manuel d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dover TWG TULSA WINCH 1500W. Dover TWG TULSA WINCH 1500W 19 pages.
Imprimer la page
OIL CHANGE
(Item 33)
Gearbox oil is drained by first removing the drain plug
by rotating the drum so that the
(Item 50) (See Fig 1)
plug is visible through the lower hole in the side plate
. Screw in a piece of 1"
pipe to allow the oil to drain, and then with a hex wrench remove the drain plug located inside of
(See Fig. 2)
the 1" pipe
. Examine the used oil for signs of significant metal deposits and then
dispose of it in a proper manner. Remove the 1" pipe.
.
Rotate the drum so that the port is visible through the upper hole in the side plate
Install a 1" pipe
(See Fig. 3)
with elbow through the upper hole in the side plate
. Fill the gearbox with 1.00 quart of
(Item 33)
See the Oil Chart on page
EP-90 oil. Remove the pipe and elbow then replace the plug
.
6 of this manual for the recommended oil type and grade for your application.
(Item 40)
Drain the brake section by removing the drain plug
under the motor along with the vent
(Item 30)
(See Fig. 4)
above the motor
. Inspect the oil for signs of metallic particles and/or burning
(Item 30). See Oil
and reinstall the drain plug. Fill with ¼ quart of non-EP oil and reinstall the vent
Chart Pg. 6 this manual for recommended oil type and grade for your application.
WIRE ROPE
Wire rope should be installed as shown in the drawing below. Note that the wedge will satisfy cable
diameters from 7/16" to 5/8", depending on how it is installed in the cable drum.
7