Amphony L1500 Manuel d'utilisation et d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Amphony L1500. Amphony L1500 17 pages. 5.8 ghz digital wireless transmitter/amplifier/receivers & headphones
Également pour Amphony L1500 : Informations sur le produit (4 pages), Spécifications (4 pages)

Imprimer la page
User and Installation Guide
Step 4
Step 4

Operating the transmitter and receiver

After powering up the transmitter, the transmit light will light for
approximately 5 seconds while the transmitter initializes.
After initialization, the transmit light will go out.
Once audio is detected at the audio input, the transmit light will light and the
transmitter will transmit the audio signal.
Switch on the speakers connected to the receiver. The audio will now be
played back through the speakers.
In order to properly set the transmitter volume control, turn the volume of the
speakers connected to the receiver to a low setting. Then feed a signal with
the highest possible volume to the transmitter. Set the transmitter volume
control to the highest level while there is still no clipping / distortion of the
audio signal. Then set the volume of the connected speakers to the desired
level.
If the transmitter level is set too low, the dynamics of the transmission are
not fully used. If the level is set too high, audio clipping (distortion) will occur
inside the transmitter.
go into standby mode after approximately 1 minute. The transmit light will go
out. During standby mode, no signal is transmitted.
Once the receiver is powered up and a valid audio signal is detected, audio
will be output at the receiver line output. When no valid audio signal is
received, the receiver audio output will be muted and the receiver will go into
standby mode.
If the transmitter or receiver are not used for an extended period of time,
remove the AC adapters from the power outlet.
Page 8
When no audio is present anymore, the transmitter will
R R