Dovre 425 Mode d'emploi Installation et entretien - Page 4
Parcourez en ligne ou téléchargez le pdf Mode d'emploi Installation et entretien pour {nom_de_la_catégorie} Dovre 425. Dovre 425 12 pages.
Imprimer la page
User Instructions
2.3
Dispose of old batteries at an appropriate recycling facility.
When using the handset:
2.4
Ensure the handset is pointed at the infrared sensor
located behind the flame effect screen at the back of the
inside of the appliance.
LOCATION OF POWER SWITCH
2.5
The mains power switch is located on the control panel on
the lower right-hand side of the appliance, see Diagram 1.
2.6
Switch ON (—) before operating either the remote or
manual controls.
2.7
A beep is heard to indicate the fire is ready for use.
Remote & Manual Operation
2.8
The following functions can be controlled using the manual
controls or remote handset:
—Heat settings 1 and 2
—Brightness of the fuel and flame effect
—Colour of the flames
2.9
The Standby function and the thermostat can only be
operated via the manual controls.
2.10
The effects can be turned off using the remote, returning the
appliance to Standby.
1
Flame effect button
Heat setting button
2
Flame effect
Heat setting 1kW
Heat setting 2kW
4
Thermostat
Standby
On/Off Switch
On/Off button
Standby On/Off
2.11
The appliance is in Standby mode when the power is
switched on via the manual control panel. You must have
this power supply ON (—) before using the manual or
remote controls (see 2.5).
Turning On the Appliance
Flame Effects:
2.12
The flame effect button on both the manual and remote
controls has 4 settings:
—Press once for maximum brightness of fuel and
flame effects.
—Press twice for medium brightness.
—Press three times for minimum brightness.
—Press four times for maximum brightness of fuel and
additional blue flame effects.
1
2
Maximum
Medium
Turning On the Heat:
2.13
When turning on the heater you must always press the
1kW button. Do not start the fire using the 2kW setting.
It is NOT advisable to run the heater without the flame
2.14
effects switched on.
2.15
Press the 1kW button to turn the fan heater ON. One
red indicator light will be displayed behind the flame effect
screen at the back of the inside of the appliance. The
appliance will blow cold air for approximately 8 seconds
before the heater comes on. On this setting the heater will
operate at half its maximum temperature.
2.16
Press the 2kW button once to turn the fan heater to its
maximum temperature. Two red indicator lights will be
displayed behind the flame effect screen at the back of the
inside of the appliance. After approximately 8 seconds the
heater will operate at its maximum temperature.
Pressing the 2kW button again will turn the heater OFF
2.17
and cold air will be blown for approximately 8 seconds to
cool the appliance.
2.18
Press the 1kW button to return to the lower heat setting.
Press the On/Off button to turn off ALL settings and
2.19
return to Standby. Cold air will be blown for
approximately 8 seconds to cool the appliance.
2.20
The appliance should be turned off via the On/Off
switch when it is not in use.
3
4
Maximum
Minimum
plus blue
flame effects