DOWINX LS-66LED Series Manuel d'instructions de montage - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} DOWINX LS-66LED Series. DOWINX LS-66LED Series 7 pages.

Imprimer la page

Assembly ②

Installation of tilt mechanism and armrest

EFirstly, remove the all screws attached to the bottom. Attach

the tilt mechanism and armrests to the cushion, then tighten

each of the removed screws to their original positions.

※ Point the front mark on the base to the guide rail.

※ Note the distinction between the left and right armrest.

Temporarily tighten all

⚠

screws to 80%

Installation of Cushion

・Assemble the upper and lower parts of the

chair as shown.

※ If lack of energy, or install it by yourself,

please place the upper side of the chair on the

ground, insert the gas cylinder into the tilt

mechanism, and pick up the chair.

Installation of Backrest

US06

●Align the steel plate with the four holes on the

backrest and screw in the 4 screws.

●With the seat cushion in a stable position, insert

the back support plate into the tilt mechanism and

install the four screws.

※ These 8 screws are stored in the screw pack.

※The back support steel plate has an inclined

design, please note that the steel plate is

inclined outward when installing.

●Then install the metal

back cover and snap it on.

Assembly ③

Adjustable headrest and Installation of Lumbar Pillow

・ The headrest can be adjusted up and

down within a certain range according to

your height.

・ Fix the lumbar pillow as shown.

※ The lumbar pillow belt is passed

through the gap between the backrest

and fixed.

Power cord connection

・LED power cord can be connected to power

bank or USB port.

※The bottom of the cushion can fix the power

bank.

※Input parameters for normal use: voltage 5V,

current 2A.

Note

・This concludes the assembly. Please confirm whether there is shaking, deformation, etc.

Then tighten all screws.

Tighten all the

⚠

screws ﬁrmly

US07