Caraudio-Systems RL-CCC-PNP Manuel - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Caraudio-Systems RL-CCC-PNP. Caraudio-Systems RL-CCC-PNP 6 pages. Interface for activation of factory rear-view camera input compatible with bmw vehicles with professional ccc navigation systems and factory pdc behind
Imprimer la page
2. Installation
Switch off ignition and disconnect the vehicle's battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
2.1.
Assignment of the female12-pin connector of harness RLC-CX011
Cable colour
Pin 1
●
pink
Pin 2
●
blue
Pin 6
●
red
Pin 8
●
yellow
Pin 9
●
green
Pin 12 ● black
2.2.
Assignment of the harness PNP-QUAD01
Cable colour
●
blue
●
yellow
●
red
● black
●
green
2.3.
Connection of the RLC-CX011 and PNP-QUAD01 harness
Connect together the following loose wires of the RLC-CX011 and PNP-QUAD01 harnesses:
yellow with yellow, blue with blue, black with black and red with red.
Connect the loose green wire on the RLC-CX011 harness to the power supply wire of the rear
view camera.
Version 08.05.2018
Assignment
+12V ACC (output) max.1.5A
CAN-LOW (input)
+12V Permanent (input)
CAN-HIGH (input)
Reverse gear (output) max. 1.5A
Ground
Assignment
CAN-LOW (output)
CAN-HIGH (output)
+12V Permanent (output)
Ground
No function
RL-CCC-PNP