Follett Maestro Chewblet 400 Series Manuel d'installation et d'entretien - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'entretien pour {nom_de_la_catégorie} Follett Maestro Chewblet 400 Series. Follett Maestro Chewblet 400 Series 20 pages. Ice machine and top kit
Également pour Follett Maestro Chewblet 400 Series : Manuel d'installation et d'entretien (20 pages), Manuel d'installation, d'utilisation et d'entretien (20 pages)
Imprimer la page
23. Connect the ice transport tube(s) to the dispenser:
a) Drill 3/16" (5mm) holes through both sides of the tube
1/2" (13mm) from the tube end.
b) Collapse tube and insert through gasketed hole (Fig. 14.1).
c) Match tube holes to bracket tabs.
24. Route bin thermostat capillary tube from the 4" x 4"
(102mm x 102mm) junction box into bin alongside the ice
transport tube. Secure capillary tube into bracket (Fig. 8).
25. Reinstall the dispenser cover with supplied screws (Fig. 14).
26. Install telescoping chase.
a) Mount lower chase section to chase bracket on counter
with supplied screws (Fig. 15.1).
b) Position upper chase section over lower chase section.
Align top of upper section to top of stainless dispenser top
and secure with screw (Fig. 15.2).
c) Drill pilot holes on both sides of chase and secure with
supplied screws (Fig. 15.3).
27. Turn icemaker power and water on.
28. After icemaker has made ice for approximately 15 minutes
complete the following start-up checks:
a) Dispense ice.
b) Hold ice on bin thermostat and make sure
icemaker shuts off.
c) Remove ice from bin thermostat and make sure
icemaker restarts.
Note: Icemaker has a 20 minute restart delay.
Fig. 14
Fig. 15
13
1
2
3
1