AmpliVox MITY-MEG PLUS SB602MR Manuel de démarrage rapide
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} AmpliVox MITY-MEG PLUS SB602MR. AmpliVox MITY-MEG PLUS SB602MR 2 pages. 25 watt megaphone
Imprimer la page
Thank you for purchasing
AmpliVox SB602MR MITY-MEG PLUS 25 Watt MEGAPHONE
We encourage you to visit our website www.ampli.com to register
your product for its warranty coverage, sign up to receive our newslet-
ter, download our catalog, and learn more about the complete line of
AmpliVox audio visual products, including portable PA systems, and
lecterns.
OPERATING INSTRUCTIONS
First,
·
Battery:
charge battery before using. Unfold the plug on the S1405 battery
pack (A) and plug into AC outlet (110V-240V). Battery will reach full charge in
approximately 2 hours. LED light on top of battery pack (B) will change from red
when charging, to green when fully charged. There is no memory effect with this
battery pack so you can recharge whenever you feel like it!
Operating Capacity and Standby Time: A fully charged battery will provide 8
·
hours of typical operation, defined as speaking 35% of the time at mid volume,
and over one year of standby / idle time.
·
Cycle Life: Lithium-ion battery pack can be expected to provide 80% of its rated
capacity after 300 charge / discharge cycles and 60% after 500 cycles. Storing,
transporting or using the battery pack at temperatures exceeding
115° F / 45° C or -4° F / - 20° C will substantially reduce the cycle life of the
battery pack.
Locate battery compartment latch on top of megaphone
·
Install Battery:
Open megaphone and insert battery into compartment (D) with led pointing up.
Close megaphone.
Battery Status:
·
The megaphone has 3 LED's LOW, MID, HIGH, (E) that will tell
you the current strength of the battery.
sufficient sound volume. Recharge the battery when LOW LED lights when
trigger is squeezed.
Talk:
·
Make sure that the switch (F) is in the Off / Talk position. Place mouth
about one inch from microphone (G), squeeze trigger (H) and speak or you can
slide switch (I) on the side of the microphone up into the locked ON position.
CAUTION: If you do not move switch into the OFF position when done,
megaphone will stay ON and drain the batteries. Microphone can also be
removed from bracket. To increase volume, rotate volume control knob (J) from
bottom to top.
When you have a freshly charged battery you may get "feedback" when talking.
To eliminate feedback you need to turn down the gain. Locate the gain control (K)
in the battery compartment. Turn until you do not hear any feedback. Less gain,
turn counter clockwise. More gain, turn clockwise.
Siren:
To activate Siren, move switch (E) to the right. Siren will be heard. There
·
is no control of the volume.
Whistle:
·
To activate Whistle, move switch (E) to the left. Whistle will be heard.
There is no control of the volume.
Property Label:
Located on the bottom of the bell. Use marking pen to write
·
ownership name on megaphone.
IF YOU HAVE ANY QUESTIONS OR PROBLEMS PLEASE CALL
OUR CUSTOMER SERVICE DEPARTMENT AT 1-800-267-5486
Note: A drained battery will not give
H
B
A
D
(C).
E
F
I
C
G
K
J