AmpliVox SW1234 Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AmpliVox SW1234. AmpliVox SW1234 8 pages. Line array speakers
Imprimer la page
OPTIONAL WIRELESS HANDHELD MICROPHONE—MODEL S1695
If you are using the Amplivox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom section of microphone
and insert 2 - "AA" 1.5 Volt alkaline batteries.
BATTERIES
1. Hold the body of microphone in hand and twist off bottom section of microphone.
2. Insert two "AA" batteries.
3. Twist bottom section back on to microphone.
BATTERY STATUS
The life expectancy of the two batteries is about 10 hours. When the "BATTERY" symbol
on the display screen keeps flashing, the batteries should be replaced immediately.
AUTO CHANNEL SYNC
Because the microphone has an Auto Sync function, you first select channel you wish to use on
the receiver. Turn on microphone, then press the ASC button,
will start to flash. Point end of microphone at the flashing IR light on the receiver and the micro-
phone will auto sync to the same channel as selected.
FUNCTIONS
Interchangeable Microphone Head
LCD Screen
Power / Mute Control Switch
Select Button
Microphone Input Sensitivity Adjustment—is used to set the gain of mi-
crophone. If you are a soft talking speaker you will need to turn the control
counter clockwise. Turn clockwise if you are a loud talker. Use plastic screw-
driver that is supplied.
MICROPHONE OPERATION AND STATUS DISPLAY
TURN ON MICROPHONE: Push and hold the "POWER/MUTE"
TO MUTE: Press "POWER/MUTE"
button again twice to remove "MUTE".
TURN OFF MICROPHONE: Push and hold the "POWER/MUTE"
"OFF".
SELECT CHANNEL: Press and hold the "SELECT"
Channel and the channel number. To change channel, when flashing, press the "SELECT"
you reach the desired channel. Flashing will stop after 10 seconds and channel is now set.
LOCK / UNLOCK CHANNEL: Push the "POWER/MUTE"
to lock or unlock channel. When locked, channel cannot be changed. "LOCKED" symbol appears in upper left-
hand corner.
button twice to MUTE. Channel number will flash when muted. Press
button for 2 seconds until you only see the word
button and "SELECT" button at the same time
on the receiver and the IR light
button until LCD screen lights up.
button for 2 seconds to turn microphone
6
button until
Microphone
End