AmpliVox SW662 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AmpliVox SW662. AmpliVox SW662 8 pages. Quad horn hailer pa system

Imprimer la page

INSTALL BATTERIES

Battery Power

1. The amp uses 10 " D " size Alkaline batteries (not included); or

the optional rechargeable AmpliVox NiCad Battery Pack (S-1465)

and (S1460) AC adapter -purchase separately (Fig 3).

2. The removable battery door on the back of the amp is

designed to stay closed until you need to change the batteries.

Slip a finger nail under it and slide it out. (Fig 1)

3. Lift the battery holder out. The plastic dividers between the

batteries help prevent battery corrosion. (Fig 2)

4. Install 10 fresh Alkaline " D" size batteries. Be sure to observe

the polarity when putting batteries in the battery compartment.

The negative (flat) ends go against the springs. (Fig 2) Carefully

replace battery holder. Batteries should look like they are

standing up.

Note: The battery holder cable comes from the factory already

plugged into the connector. If it comes loose, push it in securely.

(Turn the plug over if it doesn't fit; it only fits one way.)

5. Slide door back into place.

6. If using the S-1465 NiCad Battery Pack (Fig 3), replace battery

holder with the battery pack. Insert the battery pack plug into the connector where the battery holder was plugged

into. Plug AC Adapter/ Recharger power supply (S1460) into the "DC IN" jack on front panel of the amp. Plug into a

working electrical outlet. Charge 24 hours for full charge before using.