Follett H25T5A/W Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Follett H25T5A/W. Follett H25T5A/W 13 pages. Ice and water dispenser
Également pour Follett H25T5A/W : Manuel d'utilisation, d'entretien et de pièces détachées (17 pages)

Imprimer la page

Installation procedures

• All dispensers must be installed level in both directions to ensure proper operation.

• Required service and ventilation clearances:

• Models with integral icemakers (in top of cabinet) — 6" (15.2 cm) on right side of dispenser and at top.

• Models with remote icemakers — 12" (30.5 cm) at top.

• Freestanding models — 12" (30.5 cm) at top and 4" (10.2 cm) at back.

• All countertop and wallhung dispensers provide the option of taking utilities out the bottom or back of the

dispenser. See counter cut-out drawings for bottom exiting utilities on units with and without drain pans. For

installations where utilities will exit through back of dispenser, refer to back view drawings.

• Wallhung models are designed for use above sinks or custom drain pans and are not normally equipped

with integral drain pans. (Center of sink should be 19.5" (49.5 cm) from back wall.) Connection of utilities through

the back for wallhung units is the same as shown in drawings for countertop models except that the 3.25" (8.3 cm)

high drain pan is absent.

Installing freestanding dispensers

Do NOT tilt unit further

than 30° off vertical.

1. Carefully tip dispenser back to

expose underside and block up in

place.

2. Remove legs from shipping box

(taped to drain pan of dispenser) and

screw into dispenser bottom, taking

care to seat legs securely against

underside of dispenser.

3. Position unit in desired location and

adjust bullets on legs to level in both

directions.

4. Remove front cover of base section

and unblock shipping tie-down

securing icemaker to dispenser base.

5. Make final connections.

Note: Electrical connection box can

also be accessed through front of

dispenser by removing front cover,

black plastic chute cover and

stainless splash panel.

Before you begin

electrical

Shaded

connection

areas

box

indicate

internal

connections

38"

96.5 cm

34"

86.4 cm

28.5"

72.4 cm

9.25"

23.5 cm

3/8" FPT

icemaker drain

(air cooled only)

Rear connections — Freestanding models

access

panel

18.125"

46 cm

electrical entrance

3/4" FPT

3/8" FPT

dispenser drain

water inlet

1/2" FPT

condenser

drain (water

cooled only)

9.75"

10"

24.8 cm

25.4 cm

3/8" FPT

icemaker drain

(water cooled only)

ICDI220

10.5" (26.7 cm)

5.5" (14 cm)

3/8" FPT

condenser inlet

(water cooled only)

3.5"

8.9 cm

15"

38.1 cm