DPA 4088 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DPA 4088. DPA 4088 10 pages. Cardioid headband
Également pour DPA 4088 : Manuel (7 pages), Manuel (7 pages), Manuel de l'utilisateur (10 pages)

Imprimer la page

the cable than the standard MicroDot con-

nector from DPA Microphones. The DPA

MicroDot connector is specially designed

for use with the Kevlar® reinforced cable,

ensuring the maximum possible tensile

strength in the design. In case of failure,

MicroDot spare parts tool, and assembly

tool and assembly guide can be acquired.

Various wireless systems require the use of

electronic components inside the adapter

to optimise the signal level, the DC-offset

filtering and powering of the built-in micro-

phone preamplifier. Using the adapters

from DPA Microphones ensures the correct

electronic circuit with the listed types of

wireless systems at all times. Do not

attempt to employ non-standard adapters

or connectors as you might damage the

microphone preamplifier.

Tighten here

Not here

MicroDot connector

Adjusting the 4088 headband

The headband mount is telescopic and is

easily adjusted to fit almost any headsize.

The mount can also be widened by carefully

expanding the distance between the ear

hooks.

The 4088 headband is supplied with the

boom mounted.

To change sides simply click the boom out

of the clips and follow the instructions

below.

· Hold the boom in your right hand when

mounting on the right side and vice versa.

Hold the boom by the cable relief.

· Position your hand with the boom between

the ear hooks and turn the boom around in

the loop. Take your hand with the boom

under the headband and draw it towards you.

· Secure the microphone boom into the two

clips next to the ear hook beneath which

the boom is to be mounted. Next, secure

the boom in the clip in the middle of the

headband. This clip is movable and should

be placed near the end of the microphone

boom, before the cable relief (where the

soft cable begins to be visible). The remai-

ning two clips are not used (unless two

booms are to be mounted on the same

headband).

✗

The soft cable must not be attached

into the clips. The clips are sharp and

you will risk damaging the cable.