AMS AS5601 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AMS AS5601. AMS AS5601 12 pages. Usb interface & programming box
Également pour AMS AS5601 : Manuel de l'utilisateur (13 pages), Manuel (13 pages)

Imprimer la page
AMS AS5601 Manuel d'utilisation
AS5601-SO_RD_ST
Operation Manual
The magnet is already aligned to get AGC values in the middle of the AGC range.
Note: If the magnetic field seen by the AS5601 would be below 8mT, the output is disconnected
and permanent angle programming would not be possible. The AB quadrature interface is not
updated as long as the magnet is away.

2.4 Electrical Setup

The reference module is many used in following configurations and can be supplied with 5V or in
3.3V mode. Use J1 to enable the 3.3V mode.

2.4.1 Incremental Mode

In this mode, the power supply and the pins A and B of the reference module are connected. Over
Programming interface the Zero position and the resolution can be configured for better
performance due to hardly any individual application.
Figure 4:
Using the board in incremental Mode
µC

2.4.2 Pushbutton Detection

In this mode, the power supply and the pin Push of the reference module are connected. Over the
programming interface the pushbutton detection can be adjusted.
Figure 5:
Using the board in push button mode
µC
www.ams.com
+
-
A
B
+
-
Push
Revision 1.0 / 30.06.2014
page 6/11