Dr. Nano 12,000 LBS Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dr. Nano 12,000 LBS. Dr. Nano 12,000 LBS 13 pages.

➌

Connect the red power cord terminal on the control box to the positive (+) terminal on the

battery using a red cable.

➍

Connect the black power cord terminal on the control box to the negative (-) terminal on the

battery using a black cable.

➎

Check the direction of drum rotation. Turn the clutch knob to the "OFF" position and free

spool some rope off the drum. Turn the clutch knob to the "IN" position and push the

"IN" button on the controller, if the rope respools this is correct, if not swap the battery

leads over and recheck.

Note:

Your battery must be kept in good condition.

▪

Ensure battery cables are not drawn taught across any surfaces, which

▪

could possibly damage them.

Corrosion on electrical connections will reduce performance and could

▪

cause a short, clean all connections regularly, in salty environments use a

silicone sealer to protect from corrosion.

Wireless Control

Your Dr. Nano winch is installed with a wireless control unit housed in the control box.

This unit should have an operating range of at least 10 meters. If problems are

experienced with the wireless control, it may be of benefit to open the control box,

locate the wireless control unit attached to the inside of the case, locate the aerial and

feed it out through the bottom of the control box into a more exposed position.

Rope Installation

Unwind the new rope by rolling it along the ground, to prevent kinking. Remove old

rope and observe the manner in which it is attached to the drum flange.