Electrolux # Manuel d'instructions d'installation - Page 3

Imprimer la page

Electrolux # Manuel d'instructions d'installation

1. Cabinet Installation

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

3. Electrical connection

It is the responsibility and obligation of the consumer to

contact a qualified installer to assure that the electrical

installation is adequate and is in conformance with the

National Electrical Code ANSI/NFPA No. 70-latest

edition, or with CSA Standard C22.1, Canadian

Electrical Code, Part 1, and local codes and ordinances.

Electrical ground is required on this appliance.

These appliances are equipped with a copper conductor

flexible cable. If connection is made to aluminum house

wiring, use only special connectors which are approved

for joining copper and aluminum wires in accordance

with National Electrical Code and local codes and

ordinances.

These appliances are manufactured with a white neutral

power supply wire and a frame connected green or bare

copper grounding wire.

1. If local codes permit connection of the frame

grounding conductor to the neutral (white)

wire.

Connect the green (or bare copper) wire and the

white wire from the appliance cable to the supply

cable ground wire (white or bare) inside the junction

box. Connect the remaining wires inside the junction

box from the power supply cable to the matching

colors of the appliance cable wires (figure 2).

Cable from Power Supply

Ground Wire

R e d

Wires

Ground Wire

(Bare or Green Wire)

Cable from appliance

Figure 2

3-WIRE GROUNDED JUNCTION BOX

Improper connection of aluminum

house wiring to copper leads can result in a short

circuit or fire. Use only connectors designed for

joining copper to aluminum, and follow the

manufacturer's recommended procedure closely.

Frame grounded through the neutral.

If used in a mobile home, new branch circuit (1996

NEC) recreational vehicles or where local codes do

not permit grounding through neutral see figure 3.

2. If used in mobile homes or if local codes DO

Ground Wire

(Bare or Green Wire)

Black

Wires

system, the appliance frame MUST NOT be

connected to the neutral wire of the 4-wire

electrical system.

Junction Box

NOTE TO ELECTRICIAN: The armored cable leads

White Wire

supplied with the appliance are CSA-recognized for

U.L.-Listed Conduit

connection to larger gauge household wiring. The

Connector (or CSA listed)

insulation of the leads is rated at temperatures much

higher than temperature rating of household wiring. The

current carrying capacity of the conductor is governed by

the temperature rating of the insulation around the wire,

rather than the wire gauge alone.

Do not lift the oven by the door handle.

NOT permit connection of the frame grounding

conductor to the neutral (white) wire, separate

the white and bare copper ground wires that extend

out of the end of the supply cable of the appliance.

Connect the white wire from supply cable to the

neutral white wire in the junction box. Connect the

black and red wires from the supply cable to the

matching color wires in the junction box. The bare

wire must now be used to ground the appliance in

accordance with local electrical codes. Connect the

bare copper ground wire to the grounded lead in the

service panel. DO NOT ground to a gas supply pipe.

DO NOT connect to electrical power supply until

appliance is permanently grounded. Connect the

ground wire before turning on the power (figure 3).

Cable from Power Supply

Ground Wire

R e d

Wires

Junction Box

Cable from appliance

Figure 3

4-WIRE GROUNDED JUNCTION BOX

If connecting to a 4-wire electrical

White Wire

Black

Wires

White Wire

U.L.-Listed Conduit

Connector (or CSA listed)