Electrolux # Manuel d'utilisation et d'entretien - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux #. Electrolux # 36 pages. Over the range microwave oven
Également pour Electrolux # : Manuel d'instructions d'installation (8 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (38 pages), Livre de recettes (17 pages), Livret d'instructions (12 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'instruction (16 pages), Manuel d'instruction (12 pages), Manuel d'instruction (16 pages), Manuel de l'utilisateur (11 pages), Manuel d'utilisation et d'entretien (26 pages), Manuel d'utilisation et d'entretien (38 pages), Manuel du propriétaire (9 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'instructions d'installation (21 pages), Manuel du propriétaire (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'entretien (49 pages)

Imprimer la page
Electrolux # Manuel d'utilisation et d'entretien
Solutions to Common Problems
SURFACE BURNERS DO NOT UGHT
ii
e
[]
[]
[]
[]
[]
[]
[]
[] []
[]
[]
[]
[]
[] []
[]
[]
[] []
[]
[]
Surface Control knob has not been completely turned to LITE. Push in and turn the
Surface Control knob to LITE until burner ignites and then turn control knob to desired
flame size.
• Be sure gas supply valve is open.
• Burner ports are clogged. Clean burners. See Cleaning the Burner Grates, Burner
Caps, Burner Heads in General Care & Cleaning section. With the burner off, clean
ports with a small-gauge wire or needle.
• Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is
securely plugged into the outlet.
• Electrical power outage (electric ignition models only). Burners can be lit manually. See
Setting Surface Controls
in this Use and Care Guide.
BURNER FLAME ONLY LIGHTSHALF WAY AROUND BURNER
[]
[]
[]
[]
[]
[]
[]
[]
[] []
[]
[]
[]
[]
[] []
[]
[]
[] []
[]
[]
• Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire or
needle.
• Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until
flame is full. Dry the burners thoroughly following instructions in the General Cleaning
section.
BURNER FLAME _SORANGE
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
• Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
• In coastal areas, a slightly orange flame is unavoidable due to salt air.
[]
SCRATCHESOR ABRASIONS ON CERAMIC GLASS
COOKTOP SURFACE
[]
[]
[]
[]
[]
[]
[]
[]
[] []
[]
[]
[]
[]
[] []
[]
n
[] []
n
[]
• Coarse particles (such as salt or sand) are between cooktop and utensil. Be sure
cooktop surface and bottom of utensils are clean before use. Small scratches do not
affect cooking and will become less visible with use.
• Cleaning materials not recommended for glass ceramic cooktop have been used. See
Ceramic-Glass
Cooktop
section in this Owner's Guide.