Electrolux # Manuel du propriétaire - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Electrolux #. Electrolux # 16 pages. Over the range microwave oven
Également pour Electrolux # : Manuel d'instructions d'installation (8 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (36 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (38 pages), Livre de recettes (17 pages), Livret d'instructions (12 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'instruction (16 pages), Manuel d'instruction (12 pages), Manuel d'instruction (16 pages), Manuel de l'utilisateur (11 pages), Manuel d'utilisation et d'entretien (26 pages), Manuel d'utilisation et d'entretien (38 pages), Manuel du propriétaire (9 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'instructions d'installation (21 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'entretien (49 pages)

Imprimer la page
Electrolux # Manuel du propriétaire

General installation

1.
Connect the exhaust duct to the outside exhaust system (see
pages 4 through 6). Use of a 4" (10.2 cm) clamp (item A) is
recommended to connect the dryer to the exhaust vent system.
Use metal foil tape to seal all other joints.
2.
Carefully slide the dryer to its fi nal position. Adjust one or more of
the legs until the dryer is resting solidly on all four legs. Place a level
on top of the dryer. The dryer MUST be level and resting solidly on
all four legs. Rock alternating corners to check for stability. Remove
and discard door tape.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
3.
Plug the power cord into a grounded outlet.
4.
Turn on the power at the circuit breaker/fuse box.
5.
Read the
Use & Care Guide provided with the dryer. It contains
valuable and helpful information that will save you time and
money.
6.
If you have any questions during initial operation, please review
the "Avoid Service Checklist" in your Use & Care Guide before
calling for service.
7.
Place these instructions in a location near the dryer for future
reference.
A wiring diagram and technical data sheet are
located inside the dryer console.

Door Reversal

Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
1.
Open the dryer door. Remove the four hinge hole plugs from
the left side of the door opening. Place nearby for future
installation.
You may need a plastic knife to help pull out the
plugs. Be careful not to scratch the paint.
2.
Remove the four screws that secure the door hinges to the
dryer front panel (see right).
3.
Rotate the door 180° and reinstall the door hinges to the
dryer front panel with the four screws.
4.
Install the four hinge hole plugs in the open screw holes on
the opposite side of the door opening.
Replacement parts:
If replacements parts are needed for your dryer, contact the
source where you purchased your dryer.
1
3
2
4
- ELECTRICAL SHOCK HAZARD - Label all
wires prior to disconnection when servicing controls. Wiring
errors can cause improper and dangerous operation. Verify
proper operation after servicing.
15
A