Electrolux 241857202 Manuel d'utilisation et d'entretien - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux 241857202. Electrolux 241857202 13 pages. Top mount refrigerator

Imprimer la page

3. Remove screw and dovetail button and install on other

side, moving hole plugs from corresponding holes to

opposite side.

TO ATTACH REfRIGERATOR HANDLE:

figure 1 Style Handles

1. Secure bottom of handle with screws.

2. Secure top of handle with screws.

figure 2 Style Handles

1. Start with handle offset away from door. Place bottom of

handle over dovetail button, swing handle into an upright

position and pull upward, locking it into place.

2. Secure top of handle with screws.

To Attach Trim:

1. Slide both trim locks out of trim.

2. Insert new adhesive trim locks contained in your

literature pack.

3. Install trim to handle by sliding under base of handle.

Carefully align trim and press down at trim lock locations.

4. Use rubbing alcohol to remove any adhesive residue

from old trim lock locations.

TO REMOVE REfRIGERATOR HANDLE:

(Handles may be easier to

reverse while doors are off.)

1. Remove two screws

attaching handle to top

of refrigerator door.

2. Remove button plug

using edge of putty knife.

3. Remove screw on side

of refrigerator door and

remove handle.

4. Reverse freezer and

refrigerator handles as

shown in figure 3.

TO ATTACH REfRIGERATOR HANDLE:

1. Secure side of handle to

door and replace plug

button.

2. Secure handle to top of

door.

NOTE

Trim lock must be removed and installed by sliding over the

two donut shaped areas.

DOOR REMOVAL / REVERSAL INSTRUCTIONS

figure 3 - Handle Reversal

Refrigerator Door Without Trim

Figure 1

REMOVING STAINLESS STEEL DOORS AND

HANDLES

CAUTION

Use care when using tools near surface of stainless steel

doors to avoid scratching.

To Remove Doors

Stainless steel doors are not reversible. Follow these steps to

remove doors.

1. Remove toe grille and top hinge cover.

2. Remove top hinge and lift freezer door off of center hinge

pin. Set door aside.

3. Unscrew center hinge bin using adjustable wrench and

save for reassembly. Ensure plastic washer stays on

hinge pin.

4. Lift refrigerator door off

of bottom hinge and set

aside.

5. Remove center hinge

and shim by removing

inside screw and

loosening two outside

screws enough to allow

hinge to slide out.

6. Remove bottom hinge.

Reinsert two outside

screws in holes and tighten.

7. Reverse steps 1 - 6 to reinstall doors

To Remove Handles

1. Firmly hold freezer handle while loosening set screws

with 3/32" allen wrench. Remove freezer handle.

2. Repeat step 1 for refrigerator door.

Figure 2