Electrolux Built-In Dishwasher Manuel d'utilisation et d'entretien - Page 10

Setting Oven Controls

SETTING THE CLOCK

The

day operation. The clock has been preset at the factory for the 12 hour operation. When the

range is first plugged in, or when the power supply to the range has been interrupted, the

timer in the display will flash with "PF" (power failure, See Figure 1). Note: The clock

cannot be set when the oven is on.

When PF appears in the display, press

seconds a beep will sounds and PF will disappear.

To set the clock (example below for 1:30):

1. Press

2. Press

Figure 1

appear in the display. Press

start (Figure 4).

Figure 2

Changing between 12 or 24 hour time of day display:

1. Press and hold

down the current time of day will remain and "CLO" will disappear from the

Figure 3

display (Figure 4). CONTINUE holding the pad until a beep is heard.

2. The display will show either "12Hr" (Figure 5) or "24Hr" (Fig.6).

3. Press

The display will show either "12Hr" (Figure 5) or "24Hr" (Figure 6).

Figure 4

4. Press

change.

5. Reset the correct time as described in To set the Clock above. Please note

that if the 24 hour time of day mode was chosen, the clock will now display

Figure 5

time from 0:00 through 23:59 hours.

Figure 6

pad is used to set the clock. The clock may be set for 12 or 24 hour time of

. "CLO" will appear in the display (Figure 2).

pads to set the time of day to 1:30 (Figure 3). "CLO" will

for 8 seconds (Figure 3). While holding the pad

to switch between the 12 and 24 hour time of day display.

to accept the change or press

. No sound will be heard, but after 10

. "CLO" will disappear and the clock will

to reject the