Electrolux Built-In Dishwasher Manuel d'utilisation et d'entretien - Page 17

Care of Drain Air Gap

If a drain air gap was installed for your built-in

dishwasher, check to make sure it is clean so the

dishwasher will drain properly. A drain air gap is

usually mounted on the sink at the countertop and

can be inspected by removing the cover. This is not

part of your dishwasher and is not covered by

warranty.

Freezing temperatures may cause water lines

to rupture. Be sure all supply lines to and

circulating lines within dishwasher are

protected. Failure to do so could result in

property damage.

Care & Cleaning

WINTERIZING

A dishwasher left in an unheated place should be

protected from freezing. Have a qualified person do

the following:

To Disconnect Service:

1 Turn off electrical power to the dishwasher at

the supply source by removing fuses or

tripping circuit breaker.

2 Shut off water supply.

3 Place a pan under the inlet valve. Disconnect

water line from inlet valve and drain into pan.

4 Disconnect drain line from pump and drain

water into pan.

To Restore Service:

1 Reconnect the water, drain, and electrical

power supply.

2 Turn on water and electrical power supply.

3 Fill both detergent cups and run dishwasher

through a HEAVY WASH cycle.

NOTE

See Installation Instructions for more details.