Electrolux Built-In Dishwasher Manuel d'instruction - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Electrolux Built-In Dishwasher. Electrolux Built-In Dishwasher 27 pages. Built-in oven
Également pour Electrolux Built-In Dishwasher : Manuel d'utilisation et d'entretien (36 pages), Manuel d'utilisation et d'entretien (44 pages), Manuel d'instructions d'installation (28 pages), Manuel d'utilisation et d'entretien (28 pages), Manuel d'utilisation et d'entretien (40 pages), Manuel d'utilisation et d'entretien (27 pages), Manuel d'utilisation et d'entretien (12 pages), Manuel d'utilisation et d'entretien (22 pages), Conseils et recettes (36 pages), Manuel d'utilisation (18 pages), Manuel du propriétaire (21 pages), Manuel du propriétaire (13 pages), Manuel du propriétaire (29 pages), Manuel de l'utilisateur (27 pages), Manuel d'instruction (17 pages), Manuel d'instruction (15 pages), Livret d'instructions (18 pages), Manuel d'instruction (18 pages), Manuel d'entretien (50 pages)

Imprimer la page
Electrolux Built-In Dishwasher Manuel d'instruction

Instructions for the installer

The instructions given below are
designed specifically for a
qualified installer and should aid
him or her to perform all
installation, adjustment, and
maintenance operations with
absolute precision and in
compliance with all current
legislation and regulations. We
strongly recommend that all
operations for the installation of
your cooker be carryed out by
Qualified
accordance with existing rules
and regulations.

Electrical connection

Prior to making the electrical connection,
make sure that:
— the protection fuse and the domestic
wiring system are suitable to carry the
total electric load of the oven (see rating
plate);
— your domestic wiring system has an
efficient earth connection in compliance
with rules and laws in force;
— the wall socket or the omnipole switch
used for the electrical connection can
easily be reached after the oven is built
in.
This appliance is delivered without an
electric supply cable, therefore, you will have
to fit to it a supply cable with standard plug,
suitable for the total electric load shown on
the rating plate. The plug is to be inserted
into a suitable wall socket. If you require a
direct connection to the electric network
(mains), it will be necessary to fit between
the appliance and the mains an omnipole
switch, with a minimum gap between
contacts of 3 mm, suitable for the required
load and in compliance with rules in force.
Personnel
in
The green & yellow ground wire must not be
interrupted by the switch and it should be 2-
3 cm. longer than the other cables. The
supply cable must in all cases be laid out in
such a way as to ensure that it does not
reach at any given point a temperature 50°C
higher than the ambient temperature.
Suitable power supply cables are the
following types, considering the respective
necessary section of cable: H07 RN-F, H05
RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F.

Terminal block

The oven has an easily accessible terminal
block, which is meant to work with an
electric single-phase rate of 230 V (Fig. 29).
The Manufacturer disclaims any liability
in case these accident-preventing rules
are not observed.
Fig. 29
99