Bosch 800 Series Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Bosch 800 Series. Bosch 800 Series 40 pages. Built-in wall ovens
Également pour Bosch 800 Series : Manuel d'instructions d'installation (24 pages), Manuel d'installation (40 pages), Manuel d'utilisation et d'entretien (12 pages), Manuel d'installation (23 pages), Manuel d'installation (28 pages), Manuel d'installation (32 pages), Manuel d'instruction (32 pages), Manuel d'installation (32 pages), Manuel de démarrage rapide et de sécurité (7 pages), Manuel d'utilisation et d'entretien (40 pages), Manuel d'installation (32 pages), Manuel d'instructions d'installation (40 pages), Manuel d'installation (48 pages), Manuel d'utilisation et d'entretien (33 pages), Manuel d'utilisation et d'entretien (49 pages), Manuel de démarrage rapide (7 pages), Manuel de démarrage rapide et de sécurité (13 pages), Manuel d'installation (32 pages), Manuel d'entretien (36 pages), Manuel d'instructions d'installation (29 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (40 pages), Manuel d'instructions d'installation (28 pages)

Imprimer la page

Check Installation

Test for gas leaks

WARNING

NEVER TEST FOR GAS LEAKS USING A FLAME

If any leaks are detected, do not proceed past this

step until all leaks have been eliminated.

Leak testing is to be conducted by the installer according

to the instructions given in this section.

Turn on gas. Apply a non-corrosive leak detection fluid to

all joints and fittings in the gas connection between the

shutoff valve and the cooktop. Include gas fittings and

joints in the cooktop if connections may have been

disturbed during installation. Bubbles appearing around

fittings and connections indicate a leak. An electronic

Gas Leak Detector can also be used.

If a leak appears, turn off the supply line gas shutoff

valve and tighten the leaking connections. Retest for

leaks by turning on the supply line gas shutoff valve.

When the leak check is complete (no bubbles appear),

the test is complete. Wipe off all detection fluid residue.

Check manifold gas pressure

During any pressure testing of the gas supply piping

system at test pressures greater than 14" of water

column pressure (approximately ½" psig, 3.5 kPA) it is

necessary to disconnect the cooktop and its individual

shut-off valve from the gas supply piping system.

If it should be necessary to check the manifold gas

pressure, connect a manometer (water gauge) or other

approved gas pressure reading device to the top burner

right rear orifice. Using a rubber hose with inside

diameter of approximately 1/4" hold tubing down tight

over orifice. Turn burner valve on.

Final check

After conversion is complete, place each correct sized

burner cap in its seated, notched position and check the

operation of the electric igniters. Check flame

characteristics. Flame should be blue with a minimal

yellow tip on the outer cone of the flames.

Check flame characteristics

Yellow flames:

Further adjustment is required.

Yellow tips on outer cones:

Normal for LP Gas.

Soft blue flames:

Normal for Natural Gas.

If the flame is completely or mostly yellow, verify that

▯

the regulator is set for the correct fuel. After

adjustment, retest.

Some yellow streaking is normal during the initial start-

▯

up. Allow unit to operate 4 to 5 minutes and re-

evaluate before making adjustments.