Bosch 800 Series Manuel d'instructions d'installation - Page 11

Imprimer la page

Bosch 800 Series Manuel d'instructions d'installation

Installation of Rubber Drain Hose Adaptor

For a large port, use the drain hose as it is.

1. For a small port, insert the rubber drain hose

adaptor into the drain hose end.

2. Obtain the Rubber Drain Hose Adaptor (H)

spring clamp from the Dishwasher Installation Kit

(do not substitute).

3. Insert the drain hose adaptor into the end of the

drain hose (see Figure 14). Be sure to fully insert

the drain hose adaptor.

4. Use the clamp provided to attach the drain hose

to the house plumbing as shown in Figure 15.

Installation of Mounting Brackets

CAUTION

Before installing the supplied countertop mounting

brackets, decide which method of securing the

dishwasher into its enclosure will be used. Once the

mounting brackets are installed on the dishwasher,

removing them is difficult and will damage the mounting

brackets and the dishwasher.

The dishwasher can be secured into its enclosure in

2 ways:

NOTE: If your dishwasher opening width measures >18

in (458 mm) use the TOP OR SIDE MOUNT mounting

methods. If your dishwasher opening width measures

17.7 - 18 in (450 - 458 mm) use the ALTERNATE SIDE

MOUNT mount-ing method.

Figure 14

Figure 15

Top Mount is used for countertops made of wood

or other materials that can be easily drilled. Orient

the mounting brackets as shown in Figure 16, and

position the two small tabs on the mounting

brackets over the two slots on the dish-washer's

front corners. Push the mounting brackets down.

Side Mount is used for countertops made of

marble, granite, or other very hard materials that

cannot be easily drilled. Bend the mounting

brackets along the small holes and in the same

direction as the two small tabs. Orient the mounting

brackets as shown in Figure 17, and position the

two small tabs on the mounting brackets over the

two slots on the dishwasher's front corners. Push

the mounting brackets down firmly to insert the tabs

into the slots. Bend perforated edge down as

shown.

Alternate Side Mount for opening 17.7-18 in (450-

458 mm). Insert a side mount force distributor (Part

I) in each side as shown in Figure 18.

Figure 16

Figure 17

Figure 18