Bosch ASCENTA SHX6AP Manuel d'utilisation et d'entretien - Page 18
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Bosch ASCENTA SHX6AP. Bosch ASCENTA SHX6AP 21 pages. Bosch ascenta models dishwashers use & care manual
Également pour Bosch ASCENTA SHX6AP : Manuel d'utilisation et d'entretien (21 pages), Manuel d'utilisation et d'entretien (26 pages)
Imprimer la page
Problem
Dishes are not getting
dry enough
Odor
Dishwasher
not filling
with
water
Cause
1.
Rinse agent
dispenser
is empty.
(Rinse
agent
indicator
is activated).
2.
Improper
loading
of dishes.
3.
Selected
cycle does not include
drying.
Note: Plastic
or Teflon
do not typically
dry
as
completely
as other
items
due to their
inherent
properties.
1.
Food debris is present at the bottom of
the dishwasher.
2.
Food particles
are present near the
door seal.
3.
Dishes left too long in unit before run-
ning a cycle.
4.
Residual water is present at the bottom
of the dishwasher.
5.
Drain hose is obstructed.
Water Leaks
Tub stains
1.
Restriction in the water supply system.
2.
Previous wash cycle was not complet-
ed.
3.
Delay-start
is active.
1.
Suds
2.
Door
seal could
be pulled
away
from
track.
3.
Condensation vent is blocked.
4.
Improper installation.
1.
Stains on the dishwasher
interior are
due to hardness
of water.
2.
Silverware
in contact
with
tub.
Action
1.
Add rinse agent. The use of rinse agent im-
proves drying.
2.
Rearrange load to ensure items are not nest-
ed. Refer also to the "Preparing and Loading"
section of this manual.
3.
Rinse and Hold setting does not include dry-
ing cycle,
Note: Select models offer on extra heating options
to improve drying performance.
Refer to "Wash Cy-
cle options"
under the Operating the Dishwasher
section of this manual.
1.
Remove the filters and clean according to the
"ChecklClean the Filter System" section of this
manual.
2.
Refer to "Clean the Door Gasket and Door Seal"
in the Care and Maintenance
section of this
manual.
3.
Run a Rinse/Hold cycle if you do not intend to
immediately wash the dishes.
4.
Ensure the unit has completely drained from
the last cycle. Refer to the "Canceling or chang-
ing the cycle" section of this manual.
5.
Remove any obstructions from the drain hose
by calling qualified personnel.
Note: If odor still persists, run the Normal/Regular
cycle until it flushes end interrupt
the cycle end
place on 8 oz. cup of distilled white vinegar solu-
tion on the top rock end then finish the cycle.
1.
Ensure that
the water
supply
valve
(typically
located
under
kitchen
sink) is open and check
that
the water
supply
line has no kinks
and
clogs.
2.
Refer to the "Canceling
or changing
the cycle"
section
of this manual.
3.
Cancel the delay-start
or wait
until delay-start
time
completes
(times
out).
Refer to the "De-
lay Start" section
of this manual.
1.
Wrong type of detergent results in suds and
leaks. Use only dishwasher detergents. If suds
still persist, then add one tablespoon
of veg-
etable oil at the bottom of the dishwasher and
run the desired cycle.
2.
Ensure that door seal is in the track.
3.
Ensure that condensation vent is not blocked.
4.
Have proper installation
verified by qualified
personnel (water supply, drain system, level-
ing, plumbing).
1,
Concentrated
Lemon
juice
can
reduce
the
build up of hard water stains.
Run a normal
cy-
cle until it flushes
and interrupt
the cycle and
then
place an 8 oz. cup of the concentrated
lemon
solution
on the top rack and finish
the
cycle. This can be done
periodically
to avoid
build up.
2.
Ensure that the silverware
does not make con-
tact with the tub while
running
a cycle.
18