Advanced Control HomePro ZDW100 Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Advanced Control HomePro ZDW100. Advanced Control HomePro ZDW100 3 pages. Radio frequency controlled, 300w, 120 vac, wall mounted dimmer switch

Imprimer la page

HomePro

RF Home Automation

Shown with user supplied

Decora

trim plate

ZDW100 WALL MOUNTED DIMMER

The ZDW100 Wall Mounted Dimmer is a component of the HomePro lighting control system. Wire the Wall

Mounted Dimmer in place of the standard wall switch according to the diagram above and program from the

Wireless Controller to operate loads. Inclusion of the Wall Mounted Dimmer on the ZTH100 Wireless Controller

menu allows remote ON/OFF control and dimming of light connected.

This Wall Mounted Dimmer is designed to work with other HomePro lamp and appliance controls. Z-Wave nodes

of other types can be added to the system and will also act as repeaters if they support this function of repeating

the signal received to other modules in the system.

As part of a HomePro network, the ZDW100 will also act as a wireless repeater to insure that commands intended

for another device in the network are received. This is useful when the device would otherwise be out of the radio

range of the wireless controller.

There are no field repairable assemblies on this unit. It is covered by a one year limited warranty. If service is

needed, the unit must be returned where purchased.

CAUTION! Read and understand these instructions before installing. This device is intended for installation in

accordance with the National Electric code and local regulations in the United States, or the Canadian Electrical

Code and local regulations in Canada. It is recommended that a qualified electrician perform this installation.

To reduce the risk of overheating and possible damage to other equipment, do not install to control a

receptacle, a motor operated appliance, a fluorescent lighting fixture, or a transformer-supplied appliance,

but only permanently installed incandescent lamp fixtures. Make sure the lamp(s) to be controlled directly from

the dimmer switch total no more than 300 watts. Retain instructions for future use.

INSTALLATION

CAUTION! - SHOCK HAZARD. Make all connections with the POWER OFF to avoid injury to the installer or damage

to the device.

1. Strip 3/4" of insulation from the ends of the conductors (if not already done) and make connec-

tions as shown in the Wiring Diagram.

2. Check connections to be sure they are tight and no bare conductors are exposed.

3. Make sure the load or installation does not exceed the device rating.

4. Install into an appropriately sized electrical switch box. Scored tabs on both sides can be bent

up and down their length with pliers to break off, to allow fitting in a variety of electrical box

types.

5. Restore the power..

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.

Radio Frequency Controlled, 300W, 120 VAC,

0618-01

ZDW100

Wall Mounted Dimmer Switch

ZDW100 Instructions

082703