Bosch DISHWASHER Manuel d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Bosch DISHWASHER. Bosch DISHWASHER 28 pages. Dishwasher bosch
Également pour Bosch DISHWASHER : Manuel d'utilisation (30 pages), Manuel d'instructions d'installation (34 pages), Manuel d'utilisation (30 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (30 pages), Manuel d'utilisation (38 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (32 pages), Manuel d'utilisation (36 pages), Manuel d'utilisation (30 pages), Manuel d'utilisation (24 pages), Manuel d'utilisation (26 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (29 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (28 pages), Manuel d'instructions d'installation (50 pages), Manuel d'instructions d'installation (20 pages), Instructions de fonctionnement (24 pages), Instructions d'utilisation (36 pages), Manuel d'utilisation (25 pages), Manuel d'utilisation (46 pages), Manuel d'utilisation (31 pages)

Imprimer la page
Bosch DISHWASHER Manuel d'utilisation
en

Rinse aid %

As soon as the rinse-aid refill
indicator X is lit on the fascia, there
is still a rinse-aid reserve of 1–2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness
is over 21° dH, rinse aid must be used.
– Open the cover on the rinse-aid
dispenser 1j. To do this, press
the mark (1) on the cover
and simultaneously lift
the cover on the control plate (2).
– Carefully pour in the rinse aid to just
below the edge of the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with
a cloth.
8

Setting amount of rinse aid

The rinse aid dispensing rate can be
adjusted steplessly. The clear rinse
controller was set to 4 at the factory.
Do not change the position of the rinse aid
control unless there are streaks (rotate
towards –) or water stains (rotate towards
+) on the utensils.
Switching the rinse aid refill
indicator off or on
If the rinse-aid refill indicator X
is impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
To change the setting:
– Close the door.
– Hold down programme button 3
and press main switch ( until
the digital display 8 illuminates.
– Release buttons. On the digital display
8
is indicated (rinse-aid refill
indicator on).
– By pressing button 3 you can switch
the rinse-aid indicator off
– Switch off the main switch (;
the chosen setting has now been
stored.
5LQVH DLG
FRQWUROOHU
or on .