Bosch DISHWASHER Manuel d'instructions d'installation - Page 7

Imprimer la page

Bosch DISHWASHER Manuel d'instructions d'installation

30"

(762mm)

21"

(533mm)

Figure 5

3" - 4"

( 75mm - 100mm)

3/8" - 1/2"

( 8mm - 13mm)

Figure 6

Electrical Preparation

ELECTRICAL PREPARATION

WARNING: ELECTRICAL SHOCK

HAZARD - Working on an energized circuit

could result in serious injury or death. Only

qualified electricians should perform electri-

cal work. Do not attempt any work on the

dishwasher electric supply circuit until you

are certain the circuit is de-energized.

WARNING: FIRE HAZARD - Improper

electrical work can cause fire. Only qualified

electricians should perform electrical work.

Electrical Supply

The customer has the responsibility of ensuring that the

dishwasher electrical installation is in compliance with all

national and local electrical codes and ordinances. The

dishwasher is designed for an electrical supply of 120V, 60

Hz, AC, connected to a dishwasher-dedicated, properly

grounded electrical circuit with a fuse or breaker rated for

15 amps. If the dishwasher is connected with a food

disposer, a 20 amp (and no higher) fuse or circuit breaker

may be used. Electrical supply conductors shall be a

minimum #14 AWG copper wire.

Regardless of where the electrical supply cable enters the

enclosure (following the guidelines on page 8), position the

cable 21" (533mm) from the enclosure's left side, as

shown in Figure 5, letter A. Extend the cable 30" (762mm)

from the enclosure's back, as shown in Figure 5, letter B.

Remove 3" - 4" (75mm - 100mm) of the cable's outer

casing, as shown in Figure 6, letter C, then remove 3/8" -

1/2" (9 - 13mm) of insulation from each conductor, as

shown in Figure 6, letter D.

Dishwasher Electrical Rating

l o

s t

z t

e r

t a

s t

4 ,

(

) x