Bosch DISHWASHER Manuel d'utilisation - Page 18

Imprimer la page

Washing dishes

Reduce costs!

If only a small number of

dishes have been loaded into

the dishwasher, selecting a

programme that operates at

the next lowest temperature

will usually suffice.

Programme data

The programme specifications can be

found in the summary of instructions.

Programme specifications refer to normal

conditions. Greater deviations may occur

due to:

different amounts of dishes

temperature of mains water supply

pressure of mains water supply

ambient temperature

fluctuations in mains voltage

machine-related factors (e.g.

temperature, water volume, ...).

Energy and water consumption is reduced

by up to 1/4 when dishes are washed in

the upper basket only.

Water consumption values are based on a

water hardness setting of 4.

Aqua sensor *

* on applicable models

The Aqua sensor is an optical measuring

device which measures the turbidity of the

rinsing water. A light barrier can detect

dissolved food remnants in the water, e.g.

egg, fat and oats.

The Aqua sensor is used according to

the programme. When the Aqua sensor

is active, "clean" rinsing water may be

transferred into the next rinsing bath

and/or the temperature adjusted. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In this

way the water consumption is reduced by

approx. 4 litres for utensils which are "less"

dirty.

Downloaded from DishWasher-Manual.com Manuals

Switching the dishwasher ON

Turn on the tap.

Set main switch

Indicators light up according to the last

programme that was selected.

This same programme will run again if

no other programme button

pressed

For appliances with top basket feature:

If only the top basket is loaded, press

the top-basket button

The numerical display

expected duration of the programme.

Close door.

The programme starts automatically.

Optical indicator during

operation *

* With some models

During the rinse programme a light point

appears on the floor below the device's

door. Only open the dishwasher door

when the light point has disappeared.

In the case of built-in dishwashers with

flush front the light point will not be visible.

Remaining running time display

When the appliance has started, the

expected programme running time is

displayed. The programmed running time

is affected by the water temperature, the

number of dishes, as well as the degree

of soiling. If these conditions are changed,

the running time (depending on the

selected programme) can vary greatly.

As the effect is not detected until a

programme is running, the time may

be longer or shorter than expected.

to ON.

shows the