Airspeed FM-50 Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Airspeed FM-50. Airspeed FM-50 16 pages.
Également pour Airspeed FM-50 : Manuel du propriétaire (17 pages)
Imprimer la pageSPEAKER OUTPUTS: CLEAN and CRUNCH – Use these outputs to connect an individual channel to a speaker cabinet. For
example, you may have two (2) Airspeed 2 x 12 cabinets with different speaker sets, or you may have the Airspeed 4 x 12
diagonally switching speaker cabinet.
SPEAKER OUTPUTS: Both Channels – These output jacks output both the clean and crunch channel, whichever is selected. For
example, if you have one (1) Airspeed 2 x 12 cabinet, you would connect the speaker cabinet using one speaker cable to one of
the parallel outputs (it doesn't matter which one. There are two parallel outputs for convenience.
Section 5
FOOTSWITCH – Use this jack to connect your Airspeed 7-switch footswitch.
DELAY POSITION – This toggle switch allows you to choose whether you want the delay effect before the effects loop (pre) or
after the effects loop (post).
LOOP – This is the effects loop SEND and RETURN jacks. Use these jacks to connect outboard effects. By connecting your effects
through the SEND and RETURN jacks, you can turn them off via the Airspeed 7-switch footswitch.
3. The Airspeed 7-switch Footswitch
The Airspeed 7-switch footswitch and cable come included with the Airspeed FM-50 amplifier. Connect the cable to either side
of the footswitch, whichever is more convenient to your setup, and then connect the other end of the cable to the back of the
FM-50 amplifier. In order to enable footswitch control of your amp, switch the "Clean/Crunch" toggle switch on the front panel
of the FM-50 to CRUNCH.
As you switch the footswitch to select and turn on different amp features you will see both an LED light on the footswitch
corresponding to an LED light on the front (or back) panel indicating which feature has been selected or is "on". If the LED is not
lit it indicates that the feature is off.
IMPORTANT NOTE: When the footswitch is NOT connected, you can still switch between channels with the front panel toggle
switch. However, the default setting for the amp is to activate the following features:
Reverb for both clean and crunch channels
•
Delay
•
Tremolo
•
The effects loop
•
Boost gain
•
master volume 2
•
Airspeed FM-50 Owner's Manual, Ver 1.4
P a g e
| 7