AirStage ABYA036GTEH Manuel d'installation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AirStage ABYA036GTEH. AirStage ABYA036GTEH 16 pages.

Imprimer la page

• Setting details

Function number

Item

Indoor unit address

Refrigeration address

For use with a remote controller, set all rotary switches to 0, and refer to "7.1. Setting the

address" for details.

All switches are set to 0 at the factory.

(2) Others

Indication pattern

Indicator Name

OPERATION indicator lamp (Green)

TIMER indicator lamp (Orange)

FILTER indicator lamp (Red)

(Example) Function : 31, Setting number : 2

OPERATION

indicator

0.5s

0.5s 0.5s 0.5s

lamp (Green)

OFF

TIMER

indicator

0.5s 0.5s

lamp (Orange)

OFF

FILTER

0.5s

indicator

OFF

lamp (Red)

8. FRESH-AIR INTAKE

(1) Open up the knockout hole for the fresh-air intake (If using half-concealed installation,

open up the top knockout hole instead.)

For half concealed installation

When removing the cabinet (iron plate), be careful not to damage the indoor unit

internal parts and surrounding area (outer case).

When processing the cabinet (iron plate), be careful not to injure yourself with burrs,

etc.

(2) Fasten the round ﬂ ange (optional) to the fresh-air intake (If using half-concealed instal-

lation, attach to the top.)

Round duct (Option parts)

Setting number

00 to 63

00 to 99

Indication pattern

Function number; tens place

(0.5s ON/0.5s OFF)

Function number; ones place

(0.5s ON/0.5s OFF)

Setting number: (0 to 9) (0.5s ON/0.5s OFF)

1 cycle 12 sec

9 sec

11 sec

10 sec

Indoor unit

CAUTION

[After completing "3.3. Installing the unit"...]

(3) Connect the duct to the round ﬂ ange.

(4) Seal with a band and vinyl tape, etc. so that air does not leak from the connection.

Duct

9. FINISHING

(1) Reattach cover A and B. Then fasten the control box back into its original position us-

ing the 4 tapping screws.

Cover A

(2) Attach the remote controller cable, transmission cable, power supply cable and cable

clips. Make sure that they are positioned so that they will not interfere with opening and

closing of the intake grille or with removal and installation of the air ﬁ lters.

Cable clip

(3) Close the piping outlet with the closing material (putty etc.).

(4) Install the ﬁ lter guide.

(5) Install the intake grilles.

(6) Install side covers A and B (if the unit is installed in a half-concealed orientation, only

install side cover A).

(7) Install the air ﬁ lters.

10. TEST RUN

10.1. Test run using Outdoor unit (PCB)

• Refer to the Installation Manual for the outdoor unit if the PCB for the outdoor unit is to

be used for the test run.

10.2. Test run using remote controller

• Refer to the Installation Manual for the remote controller to perform the test run using

the remote controller.

• When the air conditioner is being test run, the OPERATION and TIMER indicator lamps

ﬂ ash slowly at the same time.

Top of the Cover B

Top of the Cover A

Cover B

Remote controller cable

Transmission cable

Power supply cable

En-14