Dragon-RC Speedo DX-10 WP45-Fan Manuel d'instruction - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dragon-RC Speedo DX-10 WP45-Fan. Dragon-RC Speedo DX-10 WP45-Fan 8 pages.
Imprimer la pageDragon - Speedo DX-10 WP45 / Speedo DX-10 WP45-Fan
Introduction
DRAGON-RC Sensored/Sensorless Brushless Speed Controller
Thank you for your purchasing the DRAGON-RC Brushless Electronic Speed
Controller (ESC). DRAGON-RC ESC is specifically designed for operating
Sensored/Sensorless brushless motors. We strongly recommend you to read
this manual instruction thoroughly before using the ESC.
In case pre-installed in a RTR car, the speedo is fully pre-set and does not not need
adjusting. In case the speedo is purchased seperate, than read the manual carefully
and select the right setting to work with your choice of motor.
Check the Dragon-rc website for an update on the manual or software as needed.
www.dragon-rc.com
Features:
l programmable electronic speed controller with small footprint
l 45A version, waterproof
l to be used for most brushless motors, bot sensored and sensorless
l to be used with max 2 or 3S lipo, or max 6 cell NIMH
l optional program card available
Begin to Use The New ESC:
Please pay attention to each connection
and make sure each assignment is correct.
6
1
2
5
3
2
8
7
4
7
4
2
1
1 Signal wire
2 Switch wire
3 Orange motor wire C
4 Power wire (+)
5 Yellow Motor wire B
6 Blue motor wire A
7 Power wire (-)
8 Capacitator wire
8
6
5
3