Electrolux Air-O-Speed Manuel d'entretien - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Electrolux Air-O-Speed. Electrolux Air-O-Speed 20 pages.

Electrolux Professional S.p.A.

Ovens Platform Customer Support

Technical Training & Service

Boiler preheating: After the filling of the boiler, the water is heated up to 85 °C (parameter SPHb) and

maintained at this temperature if the boiler is not used.

Hour counters: The hour counter parameters are the following:

hAir: hot air mode hour counter

hStM: steam mode hour counter

hcMb: combi mode hour counter

hMW: microwave ¼ hour counter

Parameter PPM: Setting this parameter to 1, the Energy Optimiser function is enabled (with Sicotronic

system) in the foreseen electric ovens. The 2 high voltage digital inputs named IND4 (X10-11/5) and IND5

(X10-11/6) and the 2 output relays RL5 and RL24 are used. RL5 is closed each time the oven has to use

the heating elements at half or full power while RL24 is closed when the heating elements have to be used at

full power (independently from Sicotronic system). IND4 and IND5 are the high voltage inputs of the

commands from Sicotronic system: if on IND4 and IND5 are present 230V the oven is working normally; if

only one is at 230V the oven is forced from Sicotronic system to work at half power (with no visualization on

the display); if both IND4 and IND5 are at 0V, the oven is forced to cut all the heating elements

Parameter dEMO: If enabled (set to 1), this parameter makes the oven working in demo function i.e. the

user interface is fully working but the oven does not make any real function (no load is activated).

10. Change of the microprocessor board

In case of changing of the microprocessor board, the following operations/calibrations have to be done:

1) Default parameter programming

2) Change parameters according parameter list

3) Lambda probe calibration

File: AOSpeed service manual (ENG).001

AOSpeed OVENS

(593800300 - ENG)

Service Manual

P.13/20