Dramm Rain Pro Expandable Manuel d'installation et de programmation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de programmation pour {nom_de_la_catégorie} Dramm Rain Pro Expandable. Dramm Rain Pro Expandable 20 pages. Expandable controller 3, 7, 11, 15 stations

Imprimer la page

1. Trouble Shooting Guide

MASTER VALVE/PUMP START WIRING

If a master valve or pump start relay is being used in

conjunction with this controller, wire as follows.

1. Route two wires from the master valve or pump start

relay up through the bottom right side large hole.

Connect one wire to the "P/MV" terminal and one to

the "Com" terminal.

2. if using a pump relay, it must be;

• Located at least 15 feet from the controller.

• Have a maximum rated inrush current less

than 350MA at 24VAC.

• Properly sized for your application

Hit Products offers a wide range of pump start relays

for most applications that are compatible with the

Rain Pro controller.

Note: DO NOT connect controller directly to pump.

Controller will be damaged if controller is connected

directly to a pump.

INSTALLING STATION MODULES

The Rain Pro controller is shipped from the factory

with one 3 station module installed. This is supplied

for valves #1, #2 and #3. Additional modules can be

purchased separately and are easily installed to

increase

the

increments, from 3 stations, to 7 stations, to 11

stations and to a maximum of 15 stations.

controller

stations

station