Bosch 8 Series Manuel d'instructions pour l'installation et l'utilisation - Page 16

Installation

Sliding out the appliance

Before you remove the appliance, protect the hob

Note:

with a piece of polystyrene from the packaging.

Use a flat-blade screwdriver to push in the fastening

bolt, and turn it 90° until it locks into place.

Push in the fastening bolt gently with your fingers,

and turn it until it comes out of the housing along

with the spring.

When doing this, grip the bottom of the appliance

with the other hand.

Caution!

Push in the fastening bolt gently with your fingers,

and turn it until it comes out of the housing with the

spring.

Carefully remove the appliance.

Screw in the filler strip fully.

Reinsert the springs and fastening bolts.

Note:

the appliance must be able to move.

Final fitting stage

Slide the appliance up into place.

Lock the fastening bolts on the left and right.

Fit the protective caps on the left and right.

Establish the electrical connection.

The extractor hood's housing can be concealed

Note:

within the upper cabinet. In doing so, you must observe

the following:

The intermediate floor must not be placed on the

■

extractor hood's housing.

The front panel must not be secured to the housing.

■

Access must be available in order to change the

■

filter and for the after-sales service.

The mounting pieces on the left and right of