Bosch FAP-OC 500Series Manuel d'entretien - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 41 pages. Built-in wall ovens
Également pour Bosch FAP-OC 500Series : Manuel d'instructions d'installation (21 pages), Manuel d'utilisation (40 pages), Manuel d'installation (6 pages), Informations sur le produit (40 pages), Manuel d'installation (28 pages), Manuel de l'utilisateur (48 pages), Manuel de l'utilisateur (48 pages), Manuel d'installation (28 pages), Manuel d'utilisation et d'entretien (44 pages), Manuel d'installation (32 pages), Manuel d'utilisation et d'entretien / Instructions d'installation (40 pages), Manuel de référence rapide (4 pages), Manuel d'utilisation et d'entretien (27 pages), Manuel d'installation (24 pages), Manuel d'installation (32 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'installation (28 pages), Manuel d'utilisation et d'entretien (21 pages), Manuel d'installation (32 pages), Manuel d'entretien (36 pages), Manuel d'installation (32 pages), Manuel de démarrage rapide et de sécurité (13 pages)

Imprimer la page
Bosch FAP-OC 500Series Manuel d'entretien
58300000202181 ARA EN B
7. Remove the screw securing the fan to the plenum.
8. Disconnect the wires and remove the fan.
9. Install the new cooling fan and reattach the wires securely.
10. Restore power to the unit and test operation.
11. Reinstall housing cover(s).
12. Slide the unit back into the cutout and reinstall the side trim
pieces.

6.12 Hinge Receivers

To replace the hinge receivers, the oven must be pulled
completely out of the cutout to provide access to the side panel(s).

6.12.1 Replacing the Hinge Receivers

1. Remove power to the oven.
2. Remove the screws securing the right and left side trim pieces
to the cabinetry.
3. Carefully slide the oven out of the cutout to gain access to the
side housing panel(s).
4. On double ovens, remove the corner brackets between the
upper and lower oven.
Figure 36 Double oven corner bracket
Copyright by BSH Home Appliances Corporation
This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.
Novemb er 2018
Figure 37 Removing the RH hinge receiver
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 500 Series Built-in Wall Ovens
5. Remove the side panel(s).
6. From the front of the oven, remove the two screws securing
the hinge receiver to the oven.
7. Pull back the side insulation to reveal the hinge receiver and
remove the part.
8. Install the new hinge receiver.
9. Reinstall the oven door and test door operation.
10. Reinstall the side housing cover.
11. Restore power to the unit and test operation.
12. Slide the oven back into the cutout and reinstall the side trim
pieces.
Page 26 of 41
800 944-2904