Draper Access XL V Manuel d'instructions - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Draper Access XL V. Draper Access XL V 8 pages. Extra large, ceiling-recessed electric screen
Également pour Draper Access XL V : Instructions Installation et fonctionnement (8 pages)
Imprimer la page
Access XL E and V 220V
Section 3 - Bottom Access XL Panel Installation/Removal
Bottom Access Panel Door
CAUTION: Beware of pinch points at ends of closure
CAUTION: The following requires two people to perform safely.
1. Press up on access panel and pull toward the front of the
screen housing to disengage hinges and remove access panel.
Access
Remove Screws
Panel Door:
Pivot on Hinges.
from both ends
of Housing.
Section 4 - Motorized Roller/Fabric Installation
1. Remove bottom access panel
2. Back out the two set screws in bracket until they are flush
with top side of bracket
(See Fig 5)
3. To engage motor end bracket flange
, rotate bracket approximately 45°
the top of the screen housing)
counterclockwise to allow top surface
of motor bracket to rest flat against top inside housing.
4. Rotate bracket clockwise until it engages in channel.
5. Engage idler end bracket in same manner as motor end bracket
and slide toward opposite end of screen housing.
Caution: Step 6 requires two people to perform safely.
6. Locate retaining clips attached to instruction sheet.
Lift roller/fabric assembly into screen housing and engage motor
head completely into motor bracket, making sure limit switch
adjusting knobs are visible from bottom of screen housing
Please Note: If snap ring is provided, make sure it engages with
motor. If retaining clip is provided instead, install to lock motor
end in place.
7. Support idler end of roller and slide mounting bracket toward
roller. Insert roller pin into nylon bushing on idler bracket
8. Roller idler pin goes through idler bracket. Reinstall washer and
retaining clip.
Caution: Failure to replace washer and retaining clip could result in separation of roller from brackets.
9. Center roller/fabric assembly by sliding mounting brackets left or right.
10. Securely tighten set screws on roller mounting brackets.
11. Connect electrical plug from motor to mating socket on junction box.
12. Attach door support brackets.
13. Reinstall bottom access panel as previously described.
Bottom flange of
Access housing
Figure 4
Removing Access Panel
.
(See Section 3)
.
(above the two channels in
(Fig. 7)
.
(Fig. 6)
Bottom access panel secures to the screen housing
with two screws
(one on each end)
position by engagement brackets with ball detents that
snap into case support brackets
Figure 3
Access case as seen from below
2. To Remove/Install support brackets:
(
Roller and Fabric standardly ship already attached in place for new unit shipments.)
IDLER END OF CASE
BOTTOM VIEW
SIDE VIEW
.
Idler End
Mounting
Figure 6
Bracket
Idler End
Retaining
Clip
, and held in the closed
.
(Fig. 3)
Figure 5
MOTOR END OF CASE
SIDE VIEW
Motor End
Mounting
Bracket
page 4 of 8
Access Panel
Support Bracket
Attaching Brackets:
Insert pin in top
1
slot and push up.
Rotate bracket
2
clockwise to lock
bracket in place.
Engagement Bracket
With Ball Detent:
will snap into Access
Panel Support Bracket.
BOTTOM VIEW
Set Screws
Motor End
Retaining Clip
Figure 7