Draper Acumen Recharge E Instructions Installation et fonctionnement - Page 8
Parcourez en ligne ou téléchargez le pdf Instructions Installation et fonctionnement pour {nom_de_la_catégorie} Draper Acumen Recharge E. Draper Acumen Recharge E 12 pages. Battery operated electric projection screen
Imprimer la page
Acumen
Recharge E & V
™
Section 9 - Tab-Tension Adjustment Procedure
Please Note: The Draper Tab-Tensioning System is factory-set, and under
normal circumstances will not require field adjustment. If wrinkles are observed,
however, follow the adjustment procedure shown in Figure 9.
Section 10 - Charging Options
This motor has a 5V built in Li-ion battery with integrated charge management. Max power input for recharging: 5V / 2 Amp.
• Once battery has been depleted, the motor must be charged for 6 hour using the reccomended AC charger.
• During operation, if voltage drops to less than 4V, the motor will beep 10 times to prompt it needs to be charged.
• Motor will stop running when the voltage is lower than 2V and it will resume again when the voltage is greater than 2.5V.
Caution: Ensure cable is kept clear of fabric.
Ensure antenna is kept straight and away from metal objects.
Charging Accessories
CAUTION: Do not touch or bend surface.
To USB Charger
USB
Charger
C088.005
END OF
DOWEL
PUSH & TURN
COUNTER-CLOCKWISE
to RELEASE TENSION
RF
Antenna
12' (4M) Charging Cable - Part#: C107.126
page 8 of 12
END OF
DOWEL
Figure 9
PUSH & TURN
CLOCKWISE
to INCREASE TENSION
Acumen Recharge Motor
Motor Charging Cable
to Motor