Bosch Series 4 Manuel d'instruction - Page 11

Setting up the appliance

The appliance must be set up directly on the kitchen

■

floor and in line with the specified dimensions. The

appliance must not be set up on any other object.

The distance between the top edge of the oven and

■

the bottom edge of the extractor hood must meet the

requirements of the extractor hood manufacturer.

Ensure that the appliance is not moved again after

■

set up. The distance from the high output burner or

wok burner to the fronts of the adjacent units or the

wall must be at least 50 mm.

Appliance height (in mm): 900 mm

Appliance width (in mm): 600 mm

Appliance depth (in mm): 600 mm

Warning – Risk of gas leak!

The appliance must not be moved once it has been

installed.

If you do move the appliance once it has been installed,

check that the connection is leak-tight.

Installation and connection

Secure all mobile parts in and on the appliance using

an adhesive tape that can be removed without leaving

any traces. Push all accessories (e.g. baking tray) into

the corresponding slots with cardboard at the edges, in

order to avoid damaging the appliance. Place

cardboard or similar between the front and rear side to

prevent knocks against the inside of the glass door.

Secure the door and, if available, the top cover to the

appliance sides using adhesive tape.

Keep the original appliance packaging. Only transport

the appliance in the original packaging. Observe the

transport arrows on the packaging.

If the original packaging is no longer available

pack the appliance in protective packaging to

guarantee sufficient protection against any transport

damage.

Transport the appliance in an upright position. Do not

hold the appliance by the door handle or the

connections on the rear, as these could be damaged.

Do not place any heavy objects on the appliance.