Bosch WAE 24364 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Bosch WAE 24364. Bosch WAE 24364 8 pages.

Imprimer la page
Safety instructions
- Read and follow the operating and installation instructions and all other information enclosed
with the washing machine.
- Retain documents for subsequent use.
Risk of electric shock
Risk of injury
Risk of posioning
Risk of suffocation
Danger to life
Risk of explosion
Consumption values
Programme
Æ Cottons 40 ºC*
ã Stains 60 ºC*
Æ Cottons 90 ºC
A Easy Care 40 ºC*
A Easy Care 40 ºC*
(also suitable as short
programme)
à Mixed Load 30 ºC
Delicates 30 ºC
u Wool 30 ºC*
* Programme setting to be tested in accordance with European standard 60 456.
Note on comparative tests: test the test programme with maximum load, Wash Plus X option
selected, maximum spin speed.
A short programme which can be used for coloured items is A Easy Care 40 ºC, without the
Wash Plus X option selected and set to maximum spin speed.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
Downloaded From WashingMachine-Manual.com Manuals
7
detergent, fluctuations in the mains voltage and selected additional functions.
Care
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Never pull out the mains plug by tugging the power cord!
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
- Never insert/pull out the mains plug with damp hands.
- Immediately remove washing and cleaning agent residue.
- Washing machine door may become very hot.
- Do not clean the appliance with a water jet.
- Caution when draining hot detergent solution.
Clean the detergent drawer ...
- Do not climb on the washing machine.
... if it contains detergent or fabric softener residue.
- Do not lean on the open washing machine door.
- Do not touch the drum in case it is still spinning.
1.
Pull out, depress insert, completely remove.
- Caution when opening the detergent drawer while washing
machine is running!
- Keep detergents and care products out of the reach of children.
2.
Open the cover.
- Keep packaging, plastic film and packaging parts out of the reach
of children.
3.
Clean with water and dry.
For worn-out appliances:
- Disconnect the mains plug.
4.
Close and lock the cover (place cylinder on guide pin).
- Sever the power cord and discard together with the plug.
5.
Insert detergent drawer.
- Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and suffocating.
- Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
Beforehand thoroughly rinse items of washing by hand.
Leave detergent drawer open so that residual water can evaporate.
Drum
Additonal
Load
Current
**
Water
**
Programme
Leave washing machine door open so that the drum can dry out.
function
duration
**
Rust stains use chlorine free cleaning agent, not steel wool.
Wash Plus X
6 kg
0.60 kWh
53 l
2:13 h
Descaling
No washing in the machine!
Wash Plus X
6 kg
1.02 kWh
45 l
2:15 h
Descale according to the instructions of the descaling agent manufacturer, not required for
Wash Plus X
6 kg
1.90 kWh
60 l
2:13 h
correct detergent dosage.
Wash Plus X
3 kg
0.55 kWh
50 l
1:24 h
Information on the display panel
-
3 kg
0.54 kWh
40 l
0:55 h
-
3 kg
0.32 kWh
35 l
0:44 h
F:16
Close the washing machine door properly; washing may be caught.
-
2 kg
0.25 kWh
38 l
0:32 h
2 kg
0.15 kWh
34 l
0:40 h
F:17
Turn the tap on fully, supply hose kinked/jammed;
clean filter -> page 10, water pressure too low.
F:18
Detergent solution pump blocked; Clean the detergent solution pump -> page 10.
Drainage hose / waste pipe blocked; Clean the drainage hose at the siphon ->
Page 10.
F:21
Motor fault. Call customer service!
F:23
Water in the base pan, appliance leaking. Call customer service!
8
Risk of electric shock!
Risk of scalding!
Maintenance
Allow detergent solution to cool down!
Pull out the mains plug!
Risk of explosion! No solvents!
Turn off the tap!
Detergent solution pump
Set programme selector to Off, pull out the mains plug.
1.
Open and remove service flap.
For models with drainage hose:
2.
Take drainage hose out of the holder and pull out of the
housing. Remove sealing cap, allow detergent solution
to flow out.
Press on sealing cap and insert drainage hose into the
holder.
For models without drainage hose:
2* Carefully unscrew pump cover until the detergent solution begins to run out.
When the service flap is half full,
screw back the pump cover and empty the service flap.
Repeat steps until all the detergent solution has run out.
3.
Carefully unscrew the pump cover (residual water).
4.
Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent solution pump must rotate).
5.
Reinsert and screw on pump cover.
6.
Insert and close service flap.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the Drain b programme.
Filters in the water supply
Risk of electric shock! Do not immerse Aqua Stop safety device in water
(contains electric valve).
Release water pressure in the supply hose:
1.
Turn off the tap!
2.
Select any programme (except Spin B/Drain b).
3.
Press Start M. Leave programme for approx. 40 seconds.
4.
Set programme selector to Off.
depending on model
5.
Remove hose from tap.
6.
Clean filter with small brush.
7.
Depending on the model, remove hose from the rear
of the appliance and clean the filter.
8.
Connect the hose and check for leaks.
Drainage hose at the siphon
Set the programme selector to Off, disconnect the mains plug.
1.
Loosen the hose clamp, carefully remove the drainage hose (residual water).
2.
Clean the drainage hose and siphon connecting piece.
3.
Reattach the drainage hose and secure the connection with the hose clamp.
9
What to do if ...
F
Water is running out.
- Correctly attach/replace drainage hose.
- Tighten screw fitting on the supply hose.
F
Water not flowing in.
- Start M not selected?
Detergent not washed in.
- Tap not open?
- Filter blocked? Clean filter -> page 10.
- Supply hose kinked or jammed?
F
Washing machine door
- Safety function active, wait for approx. 2 minutes.
cannot be opened.
- Rinse Hold (= without final spin) selected?
- Start M selected?
F
Programme does not start.
- Door closed?
- Childproof lock active? Deactivate -> page 5.
F
Detergent solution is not
- Clean detergent solution pump -> page 10.
drained.
- Clean outlet pipe and/or drainage hose.
F
Washing not spun correctly.
- Distribute small and large items of washing in the drum.
F
Spin cycle actuated several
- Not a fault - unbalanced load detection system adjusts
times.
imbalance.
F
Water not visible in the drum. - Not a fault - water below the visible area.
F
Residual water in the
- Not a fault effect of the care product not impaired.
dispenser for care product.
- Run Æ Cottons 90 ºC programme without washing.
F
Odour formation in the
washing machine.
Use standard detergent.
F
Foam is coming out of the
- Too much detergent used?
detergent drawer.
Mix 1 tablespoon of fabric softener with ½ litre of water and
pour into compartment II (not with outdoor fabrics!).
- Reduce detergent dosage for the next wash cycle.
F
Vibrations during spin cycle.
- Appliance feet fixed?
Secure appliance feet (Installation instructions).
- Transportation safety devices removed?
Remove transportation safety devices (Installation
instructions).
F
Spin result not satisfactory.
- e Reduced Ironing selected? -> page 5.
F
Display panel/indicator lights
- Power failure?
do not function while the
- Fuse tripped? Switch on/replace fuse.
appliance is running.
- If the fault occurs repeatedly, call customer service.
F
Programme progress longer
- Not a fault - unbalanced load detection system adjusts
than usual.
imbalance by repeatedly distributing the washing.
- Not a fault - foam control system active - a rinse cycle is
started.
Detergent residue on the
- Occasionally phosphate free detergents contain
F
washing.
water insoluble residue.
- Select Á SuperQuick or brush the laundry after washing.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off the tap and call customer service (Installation instructions).
10
11
Washing machine
en
Operating instructions
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 8!