Bosch WAE1826KBC Manuel d'instructions pour l'installation et l'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'installation et l'utilisation pour {nom_de_la_catégorie} Bosch WAE1826KBC. Bosch WAE1826KBC 20 pages. Front-loading washing machine

Imprimer la page

Environmental protection / Saving energy

m The most economic and least aggressive use
from an environmental point of view is always
to load the maximum amount of laundry pos

Installing the appliance

!
When installing the appliance and connect
ing it to the water supply and mains, the
guidelines and warnings indicated as well as
the general observations, regulations and
stipulations of the local water and electricity
supply companies should be closely ob
served.
!
Be careful when lifting the appliance! Danger
of injury!
!
Do not lift the appliance by its protruding
parts or controls!
!
If in doubt, you should ask a specialist techni
cian to connect the appliance to the water
supply and electric mains.
Positioning
In order to guarantee the safe and secure posi
tioning of the appliance during the spin, the sur
face or location where the appliance is to be
installed should be flat and firm. Soft floor linings,
such as fitted carpets or other materials with a
foam rubber face, are not suitable locations for
the machine.
Removing the transport security devices (pic. 1, 2)
!
Before initial use of the machine, it is essential
to remove the transport securing devices,
which are in the rear part of the machine, with
a suitable spanner.
!
Warning! Danger of injury if spanner slips!
m completely loosen and remove the 4
attachment screws and plastic parts «A».
m Assemble the protective covers «B» which
are inside the bag with the documentation.
sible into the machine according to the se
lected programme.
!
If necessary, fix the appliance to the floor us
ing attachment lugs (obtained from the Tech
nical Assistance Service) secured to the feet
of the machine (particularly when setting up
a combined column of washing and drying).
!
In the event of setting up the appliance on a
stand or raised base, it will be necessary to
secure the feet of the appliance with the lugs
in order to avoid the uncontrolled movement
of the machine during the spin cycle.
The attachment lugs can be acquired as well as a
spare set from the distributor.
Protective cover
If it is necessary to remove the protective cover in
order to install the appliance under the work sur
face, a technician should put in a cover plate to
avoid dirt, water, etc. from entering the appliance
and therefore extend its working life. This piece
may be obtained from Technical Assistance Ser
vice.
!
Keep the transport securing devices in case
you need to move the appliance in future.
!
Keep the transport securing devices in case
you need to move the appliance in future.
!
keep the bolt and plastic part together.
The appliance should only be moved with the
transport securing devices in place. To fit them,
remove the back panel «C» from the machine
and carry out the operations given above in re
verse order.
5
en