Bosch WAE20464IL Series Manuel d'instruction et instructions d'installation - Page 31
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et instructions d'installation pour {nom_de_la_catégorie} Bosch WAE20464IL Series. Bosch WAE20464IL Series 40 pages.
![Bosch WAE20464IL Series Manuel d'instruction et instructions d'installation](/uploads/products/server2/1364206/1364206.jpg)
Notes
Check the machine for transport
■
damage. Never use a damaged
machine. If you have a complaint,
please contact the retailer from
whom you purchased the appliance,
or our after-sales service.
Moisture in the drum is due to the
■
final inspection.
In addition, a hose clamp (24-40 mm
diameter, available from specialist
dealers) is required to connect the
water drain hose to a siphon.
Useful tools
Spirit level for levelling
■
Spanner with:
■
– WAF 13 for loosening the
transport locks, and
– WAF 17 for aligning the
appliance feet
Safety instructions
:
Warning
Risk of injury!
The washing machine is very heavy.
■
Be careful when lifting/transporting
the washing machine.
If the washing machine is lifted by
■
protruding components (e.g. the
washing machine door), the
components may break off and
cause injuries.
Do not lift the washing machine by
protruding parts.
If the hose and mains cables are not
■
routed properly, there is a risk of
tripping and injury.
Lay hoses and cables in such a way
that there is no risk of tripping.
Caution!
Damage to the appliance
Frozen hoses may crack/burst.
Do not install the washing machine in
areas exposed to frost and/or outdoors.
Positioning and connecting
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Notes
In addition to the safety information
■
listed here, the local water and
electricity supplier may have special
requirements.
If in doubt, have the appliance
■
connected by a specialist.
Installation surface
The washing machine must be
Note:
stable so that it does not move around.
The surface on which it is installed
■
must be firm and level.
Soft floors/floor coverings are not
■
suitable.
Installation on a base or a
wooden joist floor
Caution!
Damage to the appliance
The washing machine may "wander"
and tip/topple from the base when
spinning.
Use holding brackets to secure the feet
of the appliance.
Order no. WMZ2200, WX975600,
Z7080X0
On wooden joist floors, install the
Note:
washing machine:
In a corner, if possible,
■
On a water-resistant wooden board
■
(min. 30 mm thick) which is screwed
tightly to the floor.
en
31