Bosch WAE24167GB Manuel d'instruction et instructions d'installation - Page 28

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et instructions d'installation pour {nom_de_la_catégorie} Bosch WAE24167GB. Bosch WAE24167GB 32 pages.

Bosch WAE24167GB Manuel d'instruction et instructions d'installation
Positioning and connecting
en

Water connection

:
Warning
Risk of death!
There is a risk of electric shock if live
components are touched.
Do not immerse the AquaStop safety
valve in water (it contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Observe the following when connecting
the machine:
Notes
In addition to the information listed
here, the local water and electricity
supplier may have special
requirements.
Only operate the washing machine
using cold mains water.
Do not connect the washing
machine to the mixer tap of an
unpressurised hot-water boiler.
Do not use a used supply hose. Only
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
If in doubt, have the appliance
connected by a technician.
28

Water inlet

Notes
Do not bend, squash, modify or cut
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connection by
hand. If the screw connections are
tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow
rate is at least 8 l/min.
If the water pressure is higher than
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
tap (¾" = 26.4 mm) and to the
appliance (not necessary for AquaStop
models as this is permanently installed):
Standard model
AquaSecure model