Bosch WAE2436EBY Series Manuel d'instruction - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Bosch WAE2436EBY Series. Bosch WAE2436EBY Series 8 pages. Washing machine bosch
Imprimer la page
What to do if ...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
–
(Start/Reload) not selected?
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter –> page 10.
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Programme stopped? –> page 4.
cannot be opened.
– Is
– Can be opened by emergency release only? –> page 9.
Programme does not
–
(Start/Reload) or
start.
– Washing machine door closed?
– Childproof lock active? Deactivate –> page 5.
Detergent solution is not
– Is
drained.
– Clean the detergent solution pump –> page 10.
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Spin result not
– Distribute large and small items of laundry evenly in the drum.
satisfactory.
–
(Reduced Ironing) selected? –> page 5.
– Selected speed too low? –> page 5.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the
– Run programme
washing machine.
standard detergent.
Foam escaping from the
– Too much detergent used?
detergent drawer.
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and
Secure the appliance feet –> Installation instructions.
"wandering" during the
– Transportation safety devices removed?
spin cycle.
Remove the transportation safety devices –> Installation
instructions.
Display panel/indicator
– Power cut?
lamps do not function
– Fuses triggered? Reset/change the fuse.
during operation.
– If the fault occurs repeatedly, call customer services.
Programme sequence
– Not a fault - unbalanced load detection system adjusts
longer than usual.
imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues
– Occasionally, phosphate-free detergents contain water-insoluble
on the laundry.
residues.
– Select the
washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call customer services –> Installation instructions.
(= without final spin) selected? –> page 3, 4.
Ready in time selected?
(= without final spin) selected? –> page 3, 4.
Cottons 90 °C without laundry. Use
Rinse/
Spin cycle or brush out the laundry after
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions before
operating the washing machine.
11
Washing machine
Instruction manual
en