Draper 09536 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Draper 09536. Draper 09536 20 pages. Bench mounted spindle moulder

Imprimer la page

ADDITIONAL SAFETY INSTRUCTIONS

WARNING

For your own safety, do not operate your spindle

moulder until it is completely assembled and installed

according to the instructions....and until you have read

and understood the safety rules, assembly procedures,

adjustment procedures and maintenance etc.

1. STABILITY.

There may be a tendency for the spindle

moulder to tip over or move during certain cutting

operations, such as, working with extremely large

heavy panels or long heavy boards.

2. MINIMISE POTENTIAL ACCIDENTS.

Most accidents are caused by FAILURE TO

FOLLOW SET UP AND OPERATION INSTRUCTIONS.

Avoid awkward hand positions, where a

sudden slip could cause a hand to move into the

cutting tool. Never reach behind, or around, the

cutting tool with either hand to hold down the

workpiece, or for any other reason. DO NOT

PLACE FINGERS OR HANDS IN THE PATH OF THE

CUTTING TOOL.

3. Never reach under or over your machine when

operating or make any adjustments when it is

running.

4. Turn the spindle moulder 'OFF' and disconnect the

power supply when changing the cutting tool, or

making any adjustments.

5. Always maintain control of the workpiece. DO NOT

'LET GO' of the workpiece until the machine has

stopped.

6. When removing short workpieces, or cleaning up

around the table, be sure the router is switched

'OFF'.

7. Never turn the spindle moulder 'ON' before

clearing the table of all tools, wood scraps, etc.,

except the workpiece and related feed or support

devices for the operation.

8. When moving the spindle moulder, disconnect

power supply.

WARNING: Do not allow familiarity (gained from

frequent use of your spindle moulder) to become

commonplace. Always remember that a careless

fraction of a second is sufficient to inflict severe

injury.

9. MAKE SURE YOUR FINGERS DO NOT CONTACT

THE TERMINALS OF THE POWER PLUG when

installing or removing from the mains power

supply.

10. Do not attempt to remove excess material in one

pass.

11. Always feed against the cutter' s direction of

rotation.

12. Read and understand the instructions supplied

with the machine before attempting to use this

spindle moulder.

13. AVOID KICKBACK. Never stand directly behind the

workpiece. Under no circumstances use the mitre

guide with the fence, as a dangerous kickback may

result.

14. IF YOUR SPINDLE MOULDER MAKES AN

UNFAMILIAR NOISE OR IF IT VIBRATES

EXCESSIVELY, CEASE OPERATING IMMEDIATELY

UNTIL THE SOURCE HAS BEEN LOCATED AND THE

PROBLEM CORRECTED. sawing wood.

Do not use High speed steel (HSS) blades;

The push-stick or push block should always be

stored with the machine when not in use.

SAFE OPERATION

Use push-sticks or push blocks to feed the

workpiece past the cutter;

Use and ensure correct adjustment of the guard is

observed.

Use only cutters for which the maximum possible

speed is not less than the maximum spindle speed

of the tool and is suitable for the material to be cut.

When transporting the machine use only

transportation devices and never use guards for

handling or transportation.

- 5 -